NetComm NCT240 Installation Manual page 20

NetComm NCT240 Installation Guide
BAS/ip>?
help Display command list
? Display command list
show Display the management ip adress settings
arp Display, flush the device ARP table
set Set the management ip address and subnet mask
gateway Set the default gateway of the device's default gateway
ping Ping a remote host
root Return to the root directory.
exit Return to upper level
BAS/ip>set
Set the management ip address and subnet mask
set <ip|netmask>
ip .
netmask .
BAS/ip>set ip ixp0 192.168.1.1
Done
BAS/ip>set netmask ixp0 255.255.255.0
BAS/ip>show
ixp0 ip addr:
mac addr:
gateway:
net mask:
eth0 ip addr:
mac addr:
gateway:
net mask:
After configuring IP and Netmask, you should also configuring gateway of your network.
When the console starts, it will show the command prompt.
BAS>
You can type help or ?, and it will show all the command groups in this program. This program has
seven groups: sys, adsl, switch, isolation, ip, staticstics, and config. User can type end to terminate
this program, or to type test to enter the test program.
BAS>help
192.168.1.1
00:05:ca:00:42:11
0.0.0.0
255.255.255.0
192.168.0.1
00:05:ca:00:42:15
0.0.0.0
255.255.255.0
Release 1.0
20