Spark Plug - Mountfield 4135H Instructions For Use Manual

EN
3. Dismantle the filter assembly (26:B). The pre-
filter is placed over the air filter. Make sure that
no dirt gets into the carburettor. Clean the air fil-
ter housing.
4. Clean the paper filter by tapping it gently
against a flat surface. If the filter is very dirty,
replace it.
5. Clean the pre-filter. If the filter is very dirty, re-
place it.
6. Assemble in the reverse order.
Compressed air or petroleum-based solvents such
as kerosene may not be used for cleaning the paper
filter insert. This will damage the filter.

8.10 Spark plug

The spark plug(s) must be replaced every 200
hours of operation (=at every other basic service).
Before disconnecting the spark plug, clean around
its mounting.
Spark plug: Champion RC12YC or equivalent.
Electrode distance: 0.75 mm.
8.11 Air intake
See 19:T. The engine is air-cooled. A blocked
cooling system can damage the engine. Clean the
engine's air intake after 50 hours of operation.
More meticulous cleaning of the cooling system is
carried out during each basic service.
8.12 Lubrication
All lubrication points in accordance with the table
below must be lubricated every 50 hours of opera-
tion as well as after every wash.
Object Action
Centre point 4 grease nipples.
Use a grease gun filled with
universal grease. Pump until
the grease emerges.
Steering Brush the chains clean with
chains a wire brush.
Lubricate with universal
chain spray.
Tensioning Lubricate the bearing points
arms with an oil can when each
control is activated.
Ideally carried out by two
people.
Control Lubricate the cable ends
cables with an oil can when each
control is activated.
Must be carried out by two
people.
18
ENGLISH
8.13 Fuse
In the event of electrical faults, check/replace the
fuse, 20 A. See 20:S.
9 PATENT - DESIGN REGISTRA-
This machine or parts thereof is covered by the fol-
lowing patent and design registration:
SE9901091-0, SE9901730-3, SE9401745-6,
US595 7497, FR772384, DE69520215.4,
GB772384, SE0301072-5, SE04/000239 (PCT),
SE0401554-1, SE0501599-5.
Authorised service workshops carry out repairs
and guarantee service. They use original spare
parts.
Original spare parts are supplied by service
workshops and by Many dealers.
We recommend that the machine be handed in to
an authorised service workshop for service,
maintenance and checking of the safety devices
once a year.
11 PURCHASE TERMS
A full guarantee is issued against Manufacturing
and material defects. The user must carefully fol-
low the instructions given in the enclosed docu-
mentation.
Figure
Guarantee period
28
For consumer use: two years from purchase date.
For batteries: six months from the purchase date.
Exceptions
The guarantee does not cover damage due to:
-
- neglect of the user to acquaint himself with ac-
companying documentation
- carelessness
- incorrect and non-permitted use or assembly
29
- the use of non-genuine spare parts
- the use of accessories not supplied or approved
by GGP
Neither does the guarantee cover:
- wearing components such as blades, belts,
29
wheels and cables
- normal wear
- engine and transmission. These are covered by
the appropriate Manufacturer's guarantees with
separate terms and conditions.
The purchaser is covered by each country's
national laws. The rights to which the purchaser is
entitled with the support of these laws are not
restricted by this guarantee.
TION
10 SERVICE