Removing And Installing The Lamp Unit - Sharp XV-Z21000 Operation Manual

Removing and Installing the Lamp Unit

• The lamp unit becomes very hot while the projector is operating. Do not remove the lamp
Warning! unit from the projector right after use. The lamp and parts around the lamp will be very hot
and may cause burns or injury.
Info
• Be sure to remove the lamp unit by the han-
dle. Be sure not to touch the glass surface of
the lamp unit or the inside of the projector.
• To avoid injury to yourself and damage to the
lamp, be sure to carefully follow the steps
below.
• Do not loosen other screws than for the lamp
unit cover and lamp unit.
(As for the lamp unit, only the silver screws
are loosened.)
1
Press STANDBY on the pro-
jector or STANDBY on the re-
mote control to put the projector
into the standby mode.
• Wait until the cooling fan stops.
2
Disconnect the power cord.
• Unplug the power cord from the AC
socket.
• Leave the lamp until it has fully cooled
down (about 1 hour).
3
Remove the lamp unit cover.
• Loosen the user service screws that
secure the lamp unit cover. Then open
the cover in the direction of the arrow.
4
Remove the lamp unit.
• Loosen the securing screws from the
lamp unit. Hold the lamp unit by the
handle and pull it in the direction of the
arrow.
Optional
accessory
STANDBY
AC socket
User service screws
Lamp unit cover
Handle
Securing screws
Lamp unit
(Type: AN-K20LP)
STANDBY button
Lamp unit
Securing screw
-49