Selecting The Transmission Speed (Rs-232C); Fan Mode Setting; Reversing/Inverting Projected Images; Other Function - Sharp XV-Z21000 Operation Manual

■ Auto Power Off
This function automatically switches the projector
to Standby mode if no signals are received for a set
period.
Selectable items
ON When no input signal is detected for
more than 15 minutes, the projector will
automatically enter standby mode.
OFF The Auto Power Off function will be
disabled.
Note
• When the Auto Power Off function is set to "ON",
5 minutes before the projector enters standby
mode, the message "Enter STANDBY mode in
X min." will appear on the screen to indicate the
remaining minutes.
• When the Auto Power Off function is set to "OFF",
"LED" is set to "On" automatically. Be sure to set
the Auto Power Off function to "ON" to use the
LED Off function. (See page 43.)
e Selecting the Transmission
Speed (RS-232C)
Make sure that both the projector and computer are set
for the same baud rate.
Selectable items
9600bps Transmission speed is slow.
38400bps
115200bps Transmission speed is rapid.
r Fan Mode Setting
This function changes the fan rotation speed.
Selectable items
Normal Suitable for normal environments.
High Select this when using the projector at
altitudes of approximately 4,900 feet
(1,500 meters) or more.
•
When "Fan Mode" is set to "High", the fan rotation
speeds up, and the fan noise becomes louder.
Description
Description
Description
t Reversing/Inverting Projected
Images
This function allows the projector to be used in a wider
range of projection styles by allowing the image to be
inverted to suit the projection environment (location).
Selectable items
Front Normal image (Projected from the front
of the screen)
Ceiling + Front Inverted image (Projected from the
front of the screen with an inverted
projector)
Rear Reversed image (Projected from the
rear of the screen or with a mirror)
Ceiling + Rear Reversed and inverted image (Pro-
jected with a mirror)
See page 15 for details of Projection (PRJ) Mode.
•
y Returning to the Default Settings
Use "All Reset" to initialize all the adjustments you have
made to the default settings.
Note
The following items cannot be initialized.
• "Fine Sync" menu
— Special Modes
• "Options" menu
— Lamp Timer (Life)
— Language

Other Function

Selecting the On-screen
Display Language
The projector can switch the on-screen display language
among 11 languages.
English Français
Deutsch Italiano
Español Svenska
Nederlands Português
Menu operation ⇒ Page 34
Description
-45