Hd-Wireless Read Commands; Cr_ Hdwlmode Command; Cr_Hdwlauth Command; Cr_Hdwlinid Command - Sanyo PLC-XF1000 - 12000 Lumens Manual

PLC-XF1000 Expand Serial Command Functional Specifications

9.12 HD-wireless Read Commands

9.12.1 CR_ HDWLMODE Command

Command "CR_HDWLMODE"[CR]
Get communication mode with a radio transmitter.
Details
(Valid only when HD-wireless input is selected)
Acceptable
Response
%1
Unacceptable

9.12.2 CR_HDWLAUTH Command

Command "CR_HDWLAUTH"[CR]
Get status of the authentication between Tx-Rx.
Details
(Valid only when HD-wireless input is selected and Single mode is set)
Acceptable
Response
%1
Unacceptable

9.12.3 CR_HDWLINID Command

Command "CR_HDWLINID" [CR]
Get the ID of the transmitters.
Details
(Valid only when HD-wireless input is selected and Broadcast mode is set)
Acceptable
Response
%1
Unacceptable

9.12.4 CR_ HDWLRECEPLV Command

Command "CR_HDWLRECEPLV"[CR]
Get status of the reception level of a radio beam
Details
(Valid only when HD-wireless input is selected)
Acceptable
%1
Response
Unacceptable
%1
Unacceptable
"000_%1" [CR]
"SINGLE"------------- 1-1 mode is set
"BROADCAST"----- 1-N mode is set
"Error Code" [CR]
"000_%1" [CR]
"CONNECT"----------Authentication is success
"CONNECTING"-----Authentication in process
"DISCONNECT"------ Authentication is failure
"Error Code" [CR]
"000_%1" [CR]
"********" (Eight digits)----- ID of Tx
* is shown in capitalized letter, from 0 - F.
"Error Code" [CR]
"000_%1" [CR]
"LV0"---------------------------- reception strength: High
"LV1" ---------------------------- ↑
"LV2" ---------------------------- ｜
"LV3" ---------------------------- ｜
"LV4" ---------------------------- ｜
"LV5" ---------------------------- ｜
"LV6" ---------------------------- ｜
"LV7" ---------------------------- reception strength: Low
"Error Code" [CR]
"ON" ---------------------------- Freeze is set to ON.
"OFF" -------------------------- Freeze is set to OFF.
"Error Code" [CR]
70/72