Lexmark M410 - Optra B/W Laser Printer Service Manual page 81

4045-XXX
For each input source selected you have the following choice:
•
Single (prints the Print Test Page once)
•
Continuous (continue printing the Print Test Page until Return or
Stop is pressed).
The contents of the Print Test Page varies depending on the media
installed in the selected input source.
To run the Print Test Page:
1. Select Print Tests from the Diagnostic menu.
2. Select the media source.
3. Select Single or Continuous.
– If single is selected no buttons are active during printing.
– If continuous is selected, Return or Stop can be selected to
cancel the test.
Check each Test Page from each source to assist in Print Quality
and Paper Feed problems.
Print Quality Test Pages
The purpose of this diagnostic function is to allow printing of the print
quality test pages with the toner cartridge lockout function disabled.
The print quality test consists of three pages. Page one contains a
mixture of graphics and text. Pages two and three only contain
graphics. The Print Quality Test pages must always be printed on
letter, legal or A4 paper.
To run the Print Quality Test Pages in Diagnostic Mode:
1. Enter the Diagnostic Mode.
2. Select Print Tests from the Diagnostic menu.
3. Select Print Quality Pages from the Print Tests menu.
Diagnostic Aids
3-7