10. Insert the connector and cable of the new thermal sensor into the left hole
the two tabs on the plastic holder holding the thermal sensor with the two holes
and press the plastic holder until it snaps into position.
Figure 99. Installing the new thermal sensor
11. Reconnect the thermal sensor cable to the system board. See "Locating parts on the system board"
on page 82.
12. Reinstall the front bezel. See "Removing and reinstalling the front bezel" on page 120.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 165.
160
ThinkStation Hardware Maintenance Manual
1
in the chassis. Then align
1
and
2
in the chassis,