Speed Select Lever - Craftsman C950-52930-0 Owner's Manual

ASSEMBLY
SPEED SELECT LEVER
1. Cut plastic tie securing speed select lever assembly to
the shifter bracket. (See Figure 9)
2. Remove Iocknut, washer, spring, and the bolt. (See
Figure 11)
3. Position speed selector lever assembly as shown in
Figure 10.
4. Reinstall bolt, spring, washer and Iocknut. (See
Figure 11)
\ 0 %
Shifter Bracket
Plastic Tie_ (
Shift Lever
Figure 9
5. Tighten locknut until 1/8 to 3/16 inch of the bolt threads
protrude past the locknut
6. Thread the 3/8-16" hex jam nut onto the lever until the
nut reaches the end of the thread. (See Figure 11)
7. Thread the plastic knob as far as possible and ensure
that the knob points forward.
8. Tighten the 3/8-16" hex jam nut against the knob secure-
ly.
Control Panel
Shifter Bracket
Figure 10
9. Move shifter through all speeds to ensure proper tension
of the spring. If shifter lever sticks in any of the notches,
loosen Iocknut 1/2 turn at a time until shifter lever moves
more freely.
10. If adjustment of speed of snow blower is needed, refer to
"Friction Wheel Adjustment" in the ADJUSTMENT/RE-
PAIR section.
NOTE: View is from rightside of unit standing in operator's position.
Plastic Knob (pointed _c:::_ _8-16 Hex Jam Nut
forward) Shifter Bracket
Control Panel
Locknut
1/8 to 3/16 inch of
Exposed Thread
' Spring
Figure 11
F-0OIOO8J 10