Download Print this page

Safety Rules For Charger - Craftsman NEXTEC 320.61189 Operator's Manual

12 volt 1/4-in. lithium-ion cordless impact driver
Hide thumbs

Advertisement

SERVICE
Have your power tool serviced
by a qualified
repair person.
When servicing
a power tool, use only identical
replacement
parts.
Follow instructions
in the Maintenance
section of this manual. Use of unau-
thorized
parts or failure to follow Maintenance
instructions
may create a risk
of shock or injury.
SPECIFIC
SAFETY
RULES FOR CORDLESS
IMPACT
DRIVER
Use protective
gloves when removing the bit from the tool, or first allow the
bit to cool down. The bit may be hot after prolonged
use.
Use protective
gloves when operating
the tool. Protective
gloves can help to
keep you from being burnt and hurt.
Keep your hands away from the motor-housing
vents. Hot air comes
from
the vents during operation.
Do not operate
the tool at full-load
for more than 30 seconds,
as this can
cause the motor to become too hot, which may damage the motor.
Release the trigger immediately
when the screws are tightened
to avoid
breaking the screw.
For best results, your battery tool should
be charged
in a location
where the
temperature
is more that 32 ° F (0 ° C) but less that 104°F (40°C). Do not store
outside or in vehicles.
SAFETY
RULES FOR CHARGER
WARNING:
Read and understand all instructions. Failure to follow all instructions
listed below may result in electric shock, fire, and/or serious personal injury.
Before using the battery charger, read all instructions
and cautionary
markings
in this manual and on the battery charger, the battery, and the product using
the battery to prevent misuse of the products
and possible
injury or damage.
CAUTION:
To reduce the risk of electric
shock or damage to the charger
and battery, charge only those lithium-ion
rechargeable
batteries specifically
designated
on your charger's
label. Other types of batteries
may burst, causing
personal injury or damage.
Do not use the charger outdoors
or expose it to wet or damp conditions.
Water entering the charger will increase the risk of electric shock.
Use of an attachment
not recommended
or sold by the battery-charger
manufacturer
may result in a risk of fire, electric shock or injury to persons.
Do not abuse the cord or charger.
Never use the cord to carry the charger.
Do not pull the charger cord to disconnect
the plug from receptacle.
Dam-
age to the cord or charger could occur and create an electric shock hazard.
Replace damaged
cords
immediately.
61189
Manual_Revised_09
0306
Page 9

Advertisement

loading

  Related Manuals for Craftsman NEXTEC 320.61189