Craftsman NEXTEC 320.61189 Operator's Manual page 19

LED WORKMGHT (Fig. 6)
The LED worklight, located on
the front of the Impact Driver,
will illuminate when the trigger
switch is depressed. This
provides additional light on the
surface of the workpiece for
operation in lower-light areas.
The LED worklight will turn off
when the trigger switch
is released.
iNSTALLiNG BiTS (Fig.7)
1.
2.
3.
Lock the trigger switch by
placing the direction-of-
rotation selector in the OFF
(center) position.
With one hand, pull the
sleeve toward the front of
the tool, and hold it
in place.
With the other hand, insert
a 1/4-in. bit (available
separately) into the
hexagonal hole in the
bit retainer.
Fig. 6
LED Worklight
Fig. 7
4. Release the sleeve and
check that it returns to its
original position.
WARNING: If the sleeve does not return to its original position, the bit is not
correctly installed. Retry until the bit is properly installed and the sleeve returns to
its original position.
WARNING: Use protective gloves when removing the bit from the tool, or first
allow the bit to cool down. The bit may be hot after prolonged use.
REMOVING BiTS (Fig.7)
1. Lock the trigger switch by placing the direction-of rotation selector in the OFF
(center) position.
2. Pull the sleeve towards the front of the tool, and hold it in place.
3. Remove the bit from the hexagonal hole in the bit retainer.
4. Release the sleeve.
61189 Manual_Revised_09 0306 Page 19