Assemble Cabinet Before Mounting Saw; Mounting Door; Mounting Saw - Craftsman 113.198210 Owner's Manual

iVIOUNTBNG DOOR
Tools needed: 7/16" wrench or socket and phillips
screwd river,
1, Locate the two (2) door hinges and four (4) 10-14
x 1/2 plastite screw, Mount hinges on either side
of the door with phillips screwdriver,
2, Locate the four (4) truss head bolts, lockwasher
and hex nuts to attach door hinges to the side
panel, Tighten hex nuts with a 7/16" wrench or
socket
3 Locate the magnetic catch, the magnetic catch
stop plate, two (2) 6-19 x 1/2 pan head screws
and two (2) 6-32 x 3/8 pan head screws, Attach
the magnetic catch to the door with the two (2)
6-19 x 1/2 pan head screws using a phillips
screwdriver, Attach the magnetic catch stop
plate to the side panel opposite the side the
hinges are to be mounted. Use the two (2) 6-32 x
3/8 pan head screws to mount stop plate Adjust
the stop plate if necessary with phillips screw-
driver for desired closure,
NOTE: The framing (or combination) square must
be "true" - see start of "Assembly and Alignment"
section on page 9 for checking method.,
\
MAGNETIC CATCH
STOP PLATE
MAGNETIC
CATCH
assembae cabinet before mounting saw
NIOUNTING SAW
1., From loose parts bag 488, find the following
hardware:
4 - Truss Head Bolts 1/4-20 x 1/2
4- Lockwashers External 1/4
4- Hex Nuts 1/4-20
2. Place saw on cabinet so that holes in bottom of
saw line up with holes in top of cabinet,,
3 Install bolts, washers, lock washers, and nuts as
shown. Tighten securety using a 7/! 6" wrench or
socket,
15