Table of Contents
Advertisement
MultiModemZPX User Guide
Verifying the Windows 95/98/Me Configuration
Windows assigns an interrupt request (IRQ) number for your modem. Because the
number of IRQs is limited, a computer with several accessories may not have an
available IRQ for your new modem. In that case, you may have to decide which of
your other accessories you can modify or do without.
Be aware that resource settings should be changed only by users with expert knowl-
edge of computer hardware and hardware configurations.
Note: Changing resource settings improperly can disable your hardware and can
cause your computer to malfunction or be inoperable.
Use the following procedure to check the assignments Windows has made for your
modem:
1. Click Start | Settings | Control Panel. Double-click the System icon.
2. When the System Properties dialog box appears, click the Device Manager tab.
3. Double-click Modem to display a list of modems installed in your computer.
4. Double-click Multi-Tech Systems MT5634ZPX-PCI-V92. The Modem Proper-
5. Click the Resources tab and note the Conflicting Device list. If there is a conflict
6. In Control Panel, double-click the Modems icon.
7. When the Modems Properties dialog box appears, click the Diagnostics tab. A
8. Highlight the COM port associated with the MT5634ZPX-PCI-V92. Click More
9. Write down the modem's port, interrupt, address, and highest speed. You will
10. Click the General tab. Select Multi-Tech Systems MT5634ZPX-PCI-V92, and
11. Click Dialing Properties and review your dialing settings. If you are required to
A list of device types appears.
ties dialog box appears.
between your modem and another device in your computer, the information ap-
pears here. For help in resolving a conflict, click Start | Help, and then search
the Help index for the Hardware Conflict Troubleshooter. When finished, click
OK to exit the System Properties dialog box.
list of ports and devices appears.
Info. Clicking More Info causes Windows to send commands to and receive re-
sponses from the modem. The system also displays information about the mo-
dem's COM port.
need this information to configure any legacy (nonWindows) communications
software you install.
Port: COM ______ Interrupt: _______ Address: _________ Speed: _________
click Properties to review the modem's default communications settings. Do not
change any settings unless you have special requirements.
dial 9 to get an outside line, type 9 in the local and long distance boxes. If you
have Call Waiting service, disable Call Waiting to prevent it from interrupting a
data or fax transmission. When you are finished, click OK to exit the dialog box.
2 Installation
10
Advertisement
Table of Contents
