Friction Wheel Adjustment - Craftsman C950-52021-0 Owner's Manual

ADJ USTM ENT/RE PAlR
FRICTION WHEEL ADJUSTMENT
1. Remove bottom panels (Figure 35).
2. Position gear select lever in 1st forward gear.
3. Note position of friction wheel on disc drive plate. Proper
position from the right outer side of disc drive plate to the
centre of friction wheel must be 3" (76 mm) (see
Figure 36).
If an adjustment is required, proceed as follows:
1. Remove washer and cotter pin connecting trunnion nut
to speed rod (Figure 37).
2. Twist trunnion nut up or down on shift rod to obtain the
correct friction wheel position.
3. Put end of trunnion nut through hole in speed control rod
and reattach washer and cotter pin.
4. Reinstall bottom panels.
Remove Bolts
Loosen Bolts!_
Figure 35
Disc Drive Plate
,_ Figure 36
Speed Control Rod
J ,onoion
_._ Speed Rod _
_Wa_ _" _
Cotter Pin
Figure 37
F_01160J 27