Table of Contents
Advertisement
If you experience difficulty with the basic hardware or software setup procedures in this guide,
check the following table to see whether the difficulty you are experiencing is described. If you find
a description of the difficulty you are experiencing, try the resolution(s) recommended for the
difficulty.
If the resolution does not remove the difficulty or the difficulty is not listed in this appendix, see
Appendix B
support.
If you experience this difficulty
The XP-2000 exhibits no activity (no
LEDs are on, the fan module is not
operating, and so on).
The power supply is installed but is not
operating.
The fan is not active.
No expansion modules are active.
A specific expansion module is inactive.
An older software version continues to
boot instead of the newer version on a
TFTP server.
Enterasys X-Pedition 2000 Getting Started Guide
Troubleshooting
for information about contacting Enterasys Networks or your reseller for technical
Appendix A
Try this remedy
Make sure the power supply is installed and
plugged into a power source and the power source
is active. Also check to see whether the switch on
the power supply is in the on position.
Check the power cable and the circuit to which the
power supply is connected.
Check the power cable and the circuit to which the
power supply is connected.
Check the power cable and the circuit to which the
power supply is connected.
Make sure the expansion module has been properly
installed in its expansion slot. See Installing an
Expansion Module
on page 28
information.
Use the procedure in Loading System Image
Firmware
on page 56
to configure the XP-2000 to
boot using newer software.
for more detailed
63
Advertisement
Table of Contents
