Enterasys 5H102-48 Installation Manual page 38

Using LANVIEW
Table 4-1 LANVIEW LEDs (Continued)
LED Color
TX Off
(Transmit)
Green
Amber
Red
Speed Off
Green
4-4 Troubleshooting
State
Port enabled, and no
activity.
Should flash green every
two seconds indicating
BPDUs being sent if STA
is enabled and there is a
valid link.
Flashing. Indicates
activity. Rate indicates
data rate.
Blinking. Port may be
disabled due to Spanning
Tree.
Flashing. Indicates
collision rate.
Solid. Diagnostic failure.
Port is in 10 Mbps
(10BASE-T).
Solid. Port is in 100 Mbps
(100BASE-TX).
Recommended Action
1. Ensure that the STA is enabled and that
there is a valid link.
2. Contact Enterasys Networks for
technical support.
None.
1. Ensure that the port is not disabled.
2. Contact Enterasys Networks for
technical support.
None, unless there is a high amount of
activity. In this case, check for network
configuration problems or a defective
device.
Contact Enterasys Networks for technical
support.
None.
None.