Table of Contents
Advertisement
3. Locate four (4) leveling and eight (8) 1/2-13 hex
nuts. Attach the leveling
feet to bottom
of side
panels
in front
and rear as illustrated.
Hand
tighten
hex nuts.
WARNING: TO AVOID INJURY FROM UNEXPECT-
ED SAW OR WORK MOVEMENT,
LEVELING
FEET
MUST BE ADJUSTED
SO THAT SAW DOES NOT
ROCK. TO AVOID UNEXPECTED CARRIAGE MOVE-
MENT, ADJUST
LEVELING
FEET SO THAT THE
ARM SLOPES
SLIGHTLY
DOWNWARD
TO THE
REAR.
4. To adjust leveling feet so the saw will set properly:
a. Move saw to desired location.
b. With 3/4" wrench loosen bottom
nut.
c. Back off top nut by hand.
d. Raise or lower foot by adjusting
bottom
nut
using 3/4" wrench.
e. Snug top nut against inside of leg by hand.
f. Adjust all four feet as necessary, then tighten
all four bottom nuts using a 3/4" wrench.
CABINET
NUTS
LEVELING
FOOT
MOUNTING
SAW
1. From loose parts bag #495, find the following
hardware:
8 - Truss Head Botts 1/4-20 x 1/2
8 - Lockwashers
External 1/4
8 - Hex Nuts 1/4-20
2. Place saw on cabinet so that holes in bottom of
saw line up with holes in top of cabinet.
3. Install
bolts, Iockwashers,
and nuts as shown.
Tighten securely using a 7/16" wrench or socket.
NOTE:
It may be necessary
to loosen
the bolts
holding the skirt to the side panel of the cabinet if the
holes do not line up. Once mounting
bolt is in place
retighten
cabinet bolts securely.
SAW
BASE
_
H
jl*°
,',,,
HEX
NUT
I
6
e
ATTACHING
TRIM
CAPS & TRIM
LEDGE
1. Locate the two (2) trim caps, the trim ledge, the
six (6) type "B" #10x 1 screws and eight (8) type
BT 1/4 x 1/2 screws.
2. Place the trim ledge against the bottom
of the
base using four (4) type"B"
metal screws, secure
the trim ledge to the base from below using a
phillips
screwdriver.
TRIM
LEDGE
3. Then
reach through
the base from behind the
front table board and secure the trim ledge with
four
(4) type
"BT"
screws
using
a phillips
screwdriver.
14
Advertisement
Table of Contents
Troubleshooting
