Engine Technical Information; Product Specifications; Power Ratings - Craftsman 580.325610 Operator's Manual

ENGINETECHNICALiNFORMATiON
This is a single cylinder, overhead valve(OH\/), air cooled
engine, it is a iow emissions engine.
In the State of Caiifornia, Model 200000 engines are certified
by the California Air Resources Board to meet emissions
standards for 250 hours. Such certification does not grant
the purchaser, owner or operator of this engine any
additiona] warranties with respectto the performance or
operational iife of this engine. The engine is warranted solety
according to the product and emissions warranties stated
elsewhere in this manual.
Power Ratings
The gross power rating for individuai gas engine models is
labeled in accordance with SAE (Society of Automotive
Engineers)code J1940 (Small Engine Power & Torque
Rating Procedure), and rating performance has been
obtained and corrected in accordancewith SAEJ1995
(Revision 2002=05). Torque values are derived at 3060 RPM;
horsepower values are derived at 3600 RPM. Actuai gross
engine power wiii be lower and is affected by, among other
things, ambient operating conditions and engine-to-engine
variability. Given both the wide array of products on which
engines are piaced and the variety of environmentai issues
appiicabte to operating the equipment, the gas engine wiii not
develop the rated gross power when used in a given piece of
power equipment (actual "on-site" or net power). This
difference is due to a variety of factors including, but not
limited to, accessories (air cleaner, exhaust, charging,
cooling, carburetor, fuel pump, etc.), appiication iimitations,
ambient operating conditions (temperature, humidity,
altitude), and engine-to-engine variabiiity. Due to
manufacturing and capacity iimitations, Briggs & Stratton
may substitute an engine of higher rated power for this
Series engine.
PRODUCT S PECiFiCATiONS
Generator $pe¢ificatiens
Starting Wattage ................. 8600 Watts (8.6 kW)
Wattage ........................ 5600 Watts (5.6 kW)
AC Voltage ........................... 120/240 Volts
AC Current
at 240 Volts ........................... 23.3 Amps
at 120 Volts ........................... 46.6 Amps
Frequency ........................ 60 Hz at 3600 rpm
Phase ................................ Single Phase
FuelCapacity ......................... 5 U.S. gailons
Unit Weight ............................... 170 Ibs.
EngineSpecifications
Sore .............................. 3.12 in. (79mm)
Stroke ............................. 2.44 in. (62mm)
Displacement ...................... 18.64 in. (305 cc)
SparkPlug
ResistorType: ............. Briggs & Stratton 491055S
Long Life Piatinum: .......... Briggs & Stratton 5066D
Set Gap To: ................... O.030inch (0.76ram)
Armature Air Gap: ........ 0.008-0.012 in. (O.20-O.30mm)
Valve clearance with valve springs installed and piston 1/4 in.
(6 ram) past top dead center (check when engine is cold).
Intake ................. 0.004-0.006 in. (0.10=0.15mm)
Exhaust ............... 0.004-0.006 in. (0.10=0.15mm)
OiI Capacity .................... 28 Ounces (0.8 Liters)
NOTE:For practical operation, the generator load should not
exceed 85% of rated wattage. Engine gross horsepower wiii
decrease3-I/2% for each 1,000 feet (300 meters) above sea
level and 1% for each 10° F (5.6° C) above 77° F (25° C). It
shouid operate satisfactorily at an angie up to 15°,
14