Handle Assembly; Filterassembly; Foam Filter; Cloth Filter Bag - Craftsman 113.179345 Owner's Manual

Assembly (continued)
Handle Assembly
1. Slide handle completely on to vac cart pegs at rear of the
unit. Align holes on handle with holes on vac cart pegs and
cart handle spacers.
2_Fasten the handle to the vac cart pegs with the 10-24 x 1/2
screws.
3. Fasten the handleto the carthandle spacersw_th the 10-24x 1-1/4
SCreWS.
NOTE: Do not completelytighten screws until all screws are in
place.
Screw
10-24
x
1-1/4
"_,._ _
7 ,
I
Screw ' i
10-24 x 1/2
Vac Cart
Pegs
Filter Assembly
NOTE:Be surefiltersare properly installedbeforeusing vac.
Filters may comepre-assembled.
Foam Filter
1. Place the lid assembly of the vac upside down into the drum
or on a clean, smooth surface.
2. Slide bottom of the foam filter into circular opening of outer
filtercage.
3. Gently push down on sides, then top of foam filteruntilfilter is
secured completelyunder the outer filter cage.
4. The filter must be in correct positionat all times to avoid leaks
and possibledamage to the vac. Be certain that the foam fil-
ter cempletely covers the inner filtercage and that the bottom
of the filter rests against the lid, making sure there are no
gaps between the filter and the lid.
Cloth Filter
Bag
1. Once foam filter is in place, stretch cloth filter bag over the
outer filtercage.
2. Be sure the seams on the filter bag are facing the inside.
3. Pull down on the sides of the filter bag so that the elastic
rests under the bottom lip of the outer filter cage.
4. The filter bag should completely cover the outer filter cage
and the bottom of the filter bag should rest against the lid,
making sure there are no gaps between the filter and the lid.