Assembly; Caster System Assembly; General Set Up - Craftsman CMXEVCVVBVA1612 Instruction Manual

16 u.s. gallon wet/dry vac
Table of Contents

Advertisement

Available languages

Available languages

2. Lift the power head
5
tank
.
3. Remove the contents from inside the
collection tank
5
; make sure you have all
contents as listed on page 2.

ASSEMBLY

Caster System Assembly

4. Turn the collection tank upside down and
insert the four caster feet
on the collection tank and tighten with
17
supplied screws
feet
6
are mounted correctly. Do not over-
tighten screws. Fig. 1.
Fig. 1

GENERAL SET UP

5. Your vacuum comes ready for dry vacuum
cleaning. If the cartridge filter is not
installed, refer to page 8 for installation
instructions.
6. For wet vacuum cleaning, remove the
cartridge filter, and install the supplied foam
wet filter. See page 9-10 for the foam wet
filter installation instructions.
7. Place the power head back on the collection
tank and secure into place using the latches.
8. Insert the larger end of the hose
vacuum port on the collection tank
lock into place. Fig. 2.
13
off the collection
6
into the slots
. Verify that the caster
18
into the
5
and
Fig. 2
9. Choose the desired accessory
and/or extension wands
the end of the hose
Fig. 3
10. For quiet operation, install the noise
20
diffuser
into the blower port
inserting the locking end of the diffuser
into the blower port
clockwise to lock into place.
11. Plug the power cord into the outlet.
Turn the motor on by flipping the on/off
15
switch
to the 'I' ON position and begin
vacuuming. Fig. 4.
Fig. 4
WARNING:
COMPLETED VACUUMING, FLIP THE
ON/OFF SWITCH TO THE 'O' OFF POSITION
AND UNPLUG THE POWER CORD FROM THE
OUTLET. O = OFF
ENGLISH
21 23 25
19
and insert onto
18
. Fig. 3.
12
by
12
and turning
ONCE YOU HAVE
I = ON
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents