Installation; Powerhead Assembly; Powerhead Disassembly - Craftsman CMXEVBE176780 Instruction Manual

INSTALLATION

Powerhead Assembly (Figs. E & F)
1. Align the Powerhead Assembly Latches with the
Bucket Handle/Bale.
2. Press down firmly over each Latch to engage the
Latches with the Bucket.
Fig. E
*Installation shown is for wet pick up applications.
3. Lift the Bucket Handle/Bale to snap into the Retention
Notches of the Latches.
Fig. F
8
SP7084-1 CMXEVBE176780.indb 8
Powerhead Disassembly (Fig. G)
1. To remove the Powerhead Assembly from the
2. Remove the Hose from the Powerhead Assembly and
3. Slightly spread both Latches away from the Bucket.
4. Lift the Powerhead Assembly off the Bucket.
NOTE: To reduce the risk of tip-over when carrying by the
Powerhead
Handle/Bale, align the Powerhead Latches above the Bale
Latch (2)
attach points and be sure the Bale is snapped into the
Retention Notches on the Latches.
Fig. G
Bucket
Handle/Bale
Bucket
Bucket Handle
Powerhead
Latch (2)
Retention
Notch
Bale
Attach
Point
Bucket
Bucket, FIRST, unplug the Power Cord from the Wall
Receptacle.
rotate the Bucket Handle/Bale away from the Power
Cord.
Bucket Handle
Powerhead
Latch (2)
Retention
Notch
Bail Attach
Point
Powerhead
Latch (2)
Power
Cord
Retention
Notch
Bucket
Handle
8/3/19 7:22 AM