@ 4.11.1 Additional Corrosion; Out Of Service Procedure; From Service; To Service - Carrier ASPAX1CCA015 Installation And Owner's Manual

MAINTENANCE
Section 4 - Maintenance
1S kW Generator
@ 4.11.1 ADDITIONAL CORROSION
PROTECTION
Periodically spray all engine linkage parts and brack-
ets with corrosion inhibiting spray such as WD=40 or
a comparable product.
4.12 OUT OF SERVICE PROCEDURE
@
4o12.1REMOVAL FROM SERVICE
If the generator cannot be exercised every seven days,
and will be out of service longer than 90 days, pre-
pare tile generator Ior storage as Iollows:
1. Start the engine and let it warm tip.
2. Close the fuel shutoff valve in the fuel supply line
and allow the unit to shut down.
3. Once the unit has shut down, it will signal a low
oil fault.
4. Set the generator's main circuit breaker to its
OFF (or open) position.
5. Set the Auto/Oft/Manual switch to OFF and
turn off the utility power to the transfer switch.
Remove the 7.5A and 15A fllses from the genera=
tor control panel. Disconnect the battery cables
as outlined in "General Hazards" {page 2). Turn
on the utility power supply to the transfer switch
in order to power the emergency load centers cir-
cuits while utility" power is awJilable.
G. While the engine is still warm from running,
drain the oil completely. ReIill the crankcase with
oil. See "Engine Oil Recommendations," Section.
7. Attach a tag to the engine indicating the viscosity"
and classification of the oil in the crankcase.
8. Remove the spark plug(s) and spray fo_ging
agent into the spark plug(s) threaded openings.
Reinstall and tighten the spark plug(s).
9. Remove the battery and store it in a cool, dry
room on a wooden board. Never store the battery
on any concrete or earthen floor.
10. Clean and wipe the entire generator.
4o12o2 RETURN TO SERVICE
To return the unit to service after storage, proceed
as follows:
1. Verify that utility power is turned off and that the
Auto/Off/Manual switch is set to OFF
2. Check the tag on the engine for oil viscosity- and
classification. Verify" that the correct reeom=
mended oil is used in the engine (see "Engine Oil
Recommendations"). If necessary, drain and refill
with the proper oil.
3. Cheek the state of the battery. Fill all cells of
unsealed batteries to the proper level with dis°
tilled water. DO NOT USE TAP WATER IN THE
BATTERY. Recharge the battery to I00 percent
state of charge, or, if defective, replace the bat=
tery. See the "Specifications" Section, ior type and
size.
4. Clean and wipe the entire generator.
5. Remove the 7.5A and 15A fuses Kom the genera=
tor control panel. Reconnect the battery. Observe
battery polarity. Damage may occur if the battery
is connected incorrectly.
6. Open the iuel shutoff valve.
7. Insert the 7.5A and 15A fuses into the generator
control panel. Start the unit by moving the Auto/
Off/Manual switch to MANUAL. Allow the unit to
warm up thoroughly.
8. Stop the unit by setting the Auto/Off/Manual
switch to OFF
9. Turn on the utility power to the transfer switch.
10. Set the Auto/Off/Manual switch to AUTO.
1 1. The generator is now ready Ior service.
NOTE:
If the battery was dead or disconnected, the exer-
cise timer must be reset,
2O