Dell PowerEdge 6350 Installation And Troubleshooting Manual page 75

The subtests in the Other Test group and the functions they test follow:
ESM Firmware Status
Tests to make sure the ESM software was downloaded correctly and that the
system is operational.
ESM Interface Test
Tests the interface between the host system and the ESM system to ensure that
all bits in the data port function correctly.
ESM System Board Sensor Test
Lists the system alerts that have been recorded by the ESM system board sen-
sors. The test reports which sensor caused the alert, the failure value, and the
acceptable range the value exceeded.
ESM Backplane Sensor Test
Lists the system alerts that have been recorded by the ESM backplane sensors.
The test reports which sensor caused the alert, the failure value, and the accept-
able range the value exceeded.
ESM PSPB Sensor Test
Lists the system alerts that have been recorded by the ESM sensors on the
power supply paralleling board. The test reports which sensor caused the alert,
the failure value, and the acceptable range the value exceeded.
ESM Intrusion State Test
Reports whether the intrusion state sensor is functioning properly.
ESM Front Panel LED Test
Verifies the operation of the front panel light-emitting diodes (LEDs) by turning all
the LEDs on and off.
ESM Backplane LED Test
Verifies the operation of the backplane LEDs by turning all the LEDs on and off.
ESM System Fan Test
Checks the revolutions per minute (rpm) of the system fans and verifies the sys-
tem's ability to adjust the fans' rpm.
ESM PSPB Fan Test
Modifies the rpm of the power supply paralleling board fans to verify the accuracy
of the rpm reading.
ESM Power Supply Enable Test
Reads the power level of each power supply and then tests to verify whether the
power supplies distribute unbalanced loads evenly.
Running the Dell Diagnostics 5-25