Panasonic KV-S3105C Operating Instructions Manual page 25

Others setting menu (by pressing the OTHERS key)
Number, mode and default display
• Pressing the 3 key will change to the next
mode.
• Pressing the 4 key will change to the
previous mode.
01 Checking the version
0 1 . V e r s i o n
02 Setting the buzzer
0 2 . B u z z e r
03 Setting the SCSI ID
0 3 . S C S I I D
04 Setting the wide SCSI
0 4 . W i d e S C S I
05 Setting the transfer rate
0 5 . T r a n s f e r
2 0 M B y t e / s e c
06 Checking the roller cleaning warning
0 6 . C l e a n R o l l e r
W a r n i n g
06 Clearing the roller cleaning warning
0 6 . C l e a n R o l l e r
W a r n i n g
• Pressing the 1 key or the 2 key will change to another
value.
MX.XX: Displays the mechanical control firmware version.
IX.XX:
M t . t t
BX.XX: Displays the post-imprinter firmware version. If a
ON
O N
When the wide SCSI setting is enable:
0
N o . 6
When the wide SCSI setting is disable:
0
• Setting the SCSI ID will be activated after turning the power
off and turning it on again.
Sets "Enable" or "Disable".
• Setting the wide SCSI will be activated after turning the
E n a b l e
power off and turning it on again.
When the wide SCSI setting is disable:
20 MByte/sec
R a t e
When the wide SCSI setting is enable:
Wide 40 MByte/sec
• Changes the maximum value of the synchronous transfer
rate of the SCSI interface.
• Lower the synchronous transfer rate to 10 Mbytes/sec. if the
computer has failed to recognize the scanner or the scanner
fails to operate properly.
0%: This is displayed when "Clean Roller Warning ≤≤%"
100%: This is displayed when the roller needs to be
0 %
When pressing the 1 key and the 2 key simultaneously,
"Clean Roller Warning" will be cleared. Then "Completed" will
be displayed.
C l e a r = < >
Display Panel Instructions
Contents
Displays the Interface firmware version and the size
of expansion memory. If a Interface board is not
installed, the entry will not be displayed.
post-imprinter unit is not installed, the entry will not
be displayed.
OFF
1 2 3 . . . . . 13
4 5 6
1 2 3
10 MByte/sec
Wide 20 MByte/sec
is cleared.
cleaned.
14 15
7
25