Electrical Connection - Bosch Nexxt Series Operating, Care And Installation Instructions Manual

Electrical connection
Power cord must be connected
by a qualified person only.
Connect to individual Branch
Circuit.
Do not use an adapter.
Do not use an extension cord,
Do not remove ground prong,
For CANADA
Your dryer comes with a power
supply cord, CSA listed in Canada,
The Bosch dryer requires a 4-wire
receptacle,
When installing the receptacle for
the dryer cord, ensure that [he
power supply cord is accessible
when the dryer is in the installed
position,
The power cord should only be
replaced by a qualified person.
Use a 4_wire power supply cord
(see electrical connection U,S,A,
below).
For U.S.A.
Your dryer comes without a power
supply cord. The power cord must
meet the following requirements:
UL listed in Ihe USA
208 - 240 volt rated (minimum)
30 amps
Type SRDT or DRT (UL 2t58)
Five feet long (minimum)
Power cord mus[ be connected
by a licensed electrician only,
Use only a U.L approved
30 amp power cord with strain
relief clamp -
note manufacturer's instructions.
Do not plug end of power cord
into a live receptacle before con-
necting power cord Io appliance
IerminaIs and dosing junction/
spliIter box as described below,
Do not reuse old power cord.
Cord must have dosed loop or
upturned end wire terminaIing
connectors.
Do not make a sharp bend or
crimp wiring/conductor at con-
nectbns,
Only a 4-conductor cord shall
be used when the appliance is
installed in a mobile home, in a
recreational vehicle, in a new
branch circuit installation or an
area where lhe local codes do
not permi[ grounding through
the neutral.
Connecting 4-wire power supply
cord
1. Remove [he screws from the
cover of the terminal block
located at the top rear of the
appliance.
IPEt--_0 _ _ 2
1 terminalblock
2 groundingslrap
3 Anglebracketfor strainreliefclamp
2. Loosen the bottom screw of
the grounding strap. Place the
screw to the GROUND
IocaIion. StraighIen the
grounding sIrap and hang
loosely.
3. Fix [he strain relief clamp to [he
angle bracket, Tighten [he nut.
1
4. Loosen the 2 screws labeled L
and the screw labeled N in [he
terminal block, and the screw
of the GROUND terminal.
5. Thread the 4 wire cable through
the U.L, strain relief clamp.
6. Tighten the screws (2,5 Nm) of
the U.L, strain relief clamp so
that the power cord cannot be
moved.
7. Attach the power cord ground
conductor (green) to the
GROUND terminal. Tighten the
screw (2,5 Nm) so that the
ground conductor is held
securely in place.
8. Attach the 2 power cord outer
conductors (red and black) to
the 2 terminals labeled L and
the remaining power cord
conductor (white) to [he
terminal labeled N,
9. Tighten all 3 screws (3 Nm) so
that the power conductors are
held securely in place,