Program Selection; Automatic Programs; Time Programs; Options - Bosch Nexxt Series Operating, Care And Installation Instructions Manual

Program
selection
For optimum drying results your
dryer offers several program groups
and additional options.
Select the required drying program
from the program table according
to the examples (see page 19).
Automatic programs
There are automatic programs for
different types of textiles.
(Regular/Cotton or permanent
press).
Regular/Cotton
o.
I
2o
4Omin Airfl_
Permanent Press
The program sequence of
automatic programs is controlled
via sensors. The duration of the
program depends on the measured
degree of moisture in the laundry
and on the selected degree of
dryness (e.g. damp dry or extra dry).
[Dry woolen or wool-rich textiles
with dryer rack only!
Time programs
Time programs run for a specific
time (20, 40, 60 minutes),
In the "Air fluff" stage the dryer runs
on ambient air without a heat
supply for 20 minutes.
O ations
Delicates
Press the "Delicates" button for
temperature sensitive textiles.
Observe the care information or
symbols on the textiles, The
temperature of the drying process is
reduced, the drying time is
extended,
Signal
Your dryer outputs different signals,
if the "Signal" button is pressed,
Signal Type
Start Shorttone
End Sequence of short
tones
Sequence of longtones
Warningof Sequence of longtones
malfunction
[] The signal
"Warning of malfunction" is
active in any case.
Indicator of program
sequence
The dryer uses an electronic
scanning syslem for all programs
excepl the time programs,
A moisture sensor continuously
checks the moisture in lhe laundry.
Drying ends automatically as soon
as the selected degree of dryness
has been reached.
The drum continues Io rotate at
specific intervals for one hour Io
prevent creasing.
The current degree of drying and
Ihe level reached during Ihe
program sequence is indicated
via indicator lights (drying, damp
dry, regular dry, wrinkle
blocWfinished),
[]if the indicator light "wrinkle
block/finished" illuminates
when the program seleclor is in
Off-Position - turn off the
circuit breaker and call for
customer service!
18