Advertisement
Available languages
Available languages
ALWAYS
keep p rotective
structures,
guards,
and panels ingood r epair, inplace a nd
securely
fastened.
NEVER modify orremove
safety devices.
DO NOT c hange engine governor
settings or
over-speed
engine.
Fumes from engine exhaust can cause injury
ordeath. DO NOT r un engine inanenclosed
area. Always provide good v entilation.
ALWAYS
maintain
unit i nsafe operating
condition.
Damaged
orworn o ut m uffler can
cause fire orexplosion.
Stop a nd inspect equipment
ifyou strike a n
object orifthere i sanunusual vibration.
Repair, ifnecessary,
before restarting.
Never
make adjustments
orrepairs with the engine
running.
Mower blades are sharp and can cut y ou.
Wrap t he blade(s) orwear gloves, and use
extra c aution when s ervicing
them. NEVER
weld o rstraighten
mower blades.
Rotation
ofone blade m ay c ause rotation of
the other blades.
Check brake operation
frequently.
Adjust and
service asrequired.
Keep allhardware
properly tightened.
Stored energy insprings can cause injury.
Maintain
orreplace safety and instruction
labels, as necessary.
Never store t he machine or fuel c ontainer
inside abuilding where there i sanopen
flame, such a sawater heater.
Shut off f uel (ifprovided)
and allow engine to
cool completely
before storing inclosed area
orcovering unit.
Clean grass and debris from unit, especially
from around muffler and engine, tohelp
prevent fires.
For e xtended
storage, clean u nit t horoughly.
See Engine Manual forproper storage.
Use only a ttachments
oraccessories
designed
foryour unit.
Check attachment
components
frequently.
If
worn o rdamaged,
replace with
manufacturer's
recommended
parts.
_[.,."_"] ::1 _v_ I :) _"d
,_
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
Tools
Required
Adjustable wrench
9/16" wrench
Petroleum jelly or dielectric grease.
Unpack
Unit
Remove unit and all other components from
the shipping container. Engage transmission
bypass lever (see MOVING UNIT
MANUALLYon
page 14). Push unit from
container onto a level surface. Disengage
transmission
bypass lever.
Connect
Battery
See Battery Removal and Installation on
page 20 and perform steps 2 and 3 in the
installation section.
Place
Unit in Operating
Position
(figure
3):
NOTE: The unit is shipped with the seat
positioned as far back as possible.
1. Tip seat forward and adjust the seat as
needed (see ADJUSTING
STEERING
LEVERS on page 21).
2. Remove eccentric spacers and rotate
steering levers to the operating position.
reinstall spacers. Do not tighten.
3. Adjust steering levers (see ADJUSTING
STEERING LEVERS on page 21).
2
1. Seat
2. Steering Lever
3. Eccentric
4.
Handlebar
Brackets
Figure 3
GB-9
Advertisement
