Installing The Power Supply; Connecting The Ports And Leds; Connecting The Usb Ports; Connecting The Ieee 1394 - Antec Nine Hundred User Manual

Installing the Power Supply

1. With the case upright, place the power supply on the four silicone pads on
the bottom of the case.
Note: Power supplies with fans on the bottom
of the power supply will need to be mounted so
that the fan is facing the top of the case. Nine
Hundred provides mounting holes for power
supplies with standard mounting layouts to be
installed upside up or upside down.
2. Push the power supply to the back of the case
and align the mounting holes.
3. Attach the power supply to the case with the screws provided.

Connecting the Ports and LEDs

Note: Please refer to your motherboard manual for specific pin outs or location of
front panel connectors.
1. Connect the Reset switch (labeled RESET SW) to the motherboard at the RST
connector. Polarity (positive and negative) does not matter for switches.
2. Power Switch (labeled POWER SW) connects to the PWR connector on the
motherboard.
3. There is no Power LED in this case. Three illuminated case fans will turn on
when there is power to the computer.
4. Hard Drive LED (labeled H.D.D. LED) connects to the IDE connector. For
LEDs, colored wires are positive (+). White or black wires are negative (–). If
the LED does not light up when the system is powered on, try reversing the
connection. For more info on connecting LEDs to your motherboard, see your
motherboard manual.

Connecting the USB Ports

Note: Please check the motherboard manual for the USB header pin layout and
make sure it matches the table below.
1 2
9 10
Connecting the IEEE 1394 (FireWire®, i.Link®) Port
Note: Please check the motherboard manual for your IEEE 1394 header pin layout
and make sure it matches the following table. If you intend to connect the front
FireWire port to an IEEE 1394 add-on card that comes with an external-type IEEE
1394 connector, you will need a FireWire Internal Adapter. To order one, please
visit Antec's web store at http://www.antec.com/StoreFront.bok and search for
part number 30031. This adapter will allow you to connect the front IEEE 1394
port to the external-type connector.
Motherboard USB Pin Layout
Pin Signal Names
1
USB Power 1
3
Negative Signal 1
5
Positive Signal 1
7
Ground 1
9
Key (No Connection)
Pin
2
4
6
8
10
3
Signal Names
USB Power 2
Negative Signal 2
Positive Signal 2
Ground 2
Empty Pin