GE JGBS04 Owner's Manual And Installation Instructions page 18

Care and cleaning of the range.
Usea sewing needle or twist-tie
to unclog the small hole h7ttTe
burner head.
Burner Caps and Heads (on sealed burners only)
NOTE: Before removing the burner caps
and heads, remember their ske and location.
Replace them in the same location after
cleaning.
Burner caps
I Jfl off when cool. _Vash burner caps
in hot, soapy water and i_inse with clean
watei: ¥(/u mat scour with a I)lasfic sc(/m_ing
pad to remoxe burned-on food pm-ticles.
Burner heads
For proper ignition, make sure the
small hole in the section that fits oxer the
electrode is kept open. A sewing needle
or wire twist-tie worLs well to unclog it.
The slits in the burner heads must be kept dean
at aft times for an even, unhampered flame.
Replacement
]_epla('e burner heads over the electrodes
on the cooktop, in the correct htcafions
according to flmir size.
Medium head Sma! I head
r l
Medium head Large head
(:logged or (lirD' burner pails or electrodes
lJll not allow the burner to operate properly,
AIV spill on or around an electrode m ust
be carefilllv cleaned. Take care to not hit an
electrode with an}_hing hard or it could
be damaged.
Make sure the shit in the burner head is
positioned over fl_e elecu'ode.
Y})u should clean the burner caps and
burner heads routinely, especially alter bad
spilloveI_, which could clog the openings
in the burner heads, i.ifl offwhen cool.
To remove burned-on fl)od, soak the
burner heads in a solution of mild liquid
detergent and hot water fin" 20-30 minutes,
For more stubborn stains, use a toothbrush.
After cleaning
Before putting the burner caps and heads
back, shake ()tit excess water and then (lr)
them thoroughl_ l)_ setting in a wam_ oxen
fi)r 30 minutes.
NOTE: Do not use steel wool or scouring powders
to dean the burners.
Replace the matching size caps onto the
heads. There is one small, two medium
and one large cap. Sizes are stamped into
the bottom of fl_e caps.
Medi]in cap •
Sma,, cap
t
Medium cap Large cap
Make sure that the heads and caps are
replaced in the correct locations,
NOTE: On some models, the burners are a// the
same sizeand poweg
/8