Advertisement
1) Front-Floor : Normal Image
2) Front-Ceiling : Horizontal/Vertical Reversed Image
3) Rear-Floor : Horizontally Reversed Image
4) Rear-Ceiling : Vertically Reversed Image
Lamp Mode
Used to set the image brightness by adjusting the amount of light generated by the lamp.
1) Eco : This mode is optimized for small screens smaller than 100 inches.
This mode decreases the lamp brightness and power consumption in order to extend
the lamp lifetime and reduce noise and power consumption.
2) Normal : This mode is optimized for general use. This mode is the recommended
mode for a stable lamp brightness that enables a low-noise, comfortable operating
environment even under bright ambient illumination.
3) Bright : This mode maximizes the lamp brightness when the ambient illumination is
bright. As the brightness of the lamp increases, the lamp lifetime can be reduced and
the noise and power consumption may increase.
V-Keystone
When the projector image is not displayed vertically on the screen, the image can be
calibrated using the V-Keystone function.
H-Keystone
When the projector image is not displayed horizontally on the screen, the image can be
calibrated using the H-Keystone function.
Refer to
'Adjusting the
▶The Keystone, which is a function for calibrating a skewed image, may degrade
image quality when it is activated.
Background
You can set the Background that is displayed when there is no signal from the external device
connected to the projector.If a signal is received, the Background you set disappears and a
normal screen is displayed.
1) Logo
2) Blue
3) Black
Test Pattern
Generated by the projector itself. Use to optimize the installation of the projector.
1) Crosshatch : You can check whether the picture is distorted or not.
2) Screen Size : You can refer to picture format sizes such as 1.33:1 or 1.78:1.
Video Type
If the screen quality is abnormal as a result of the projector not identifying the input signal
type automatically in PC or HDMI mode, you can manually set the input signal.
In [PC] mode, this is only enabled if the input signal is
▶
Sub).However, for a separate H/V sync., this is only enabled for the 1280 x
720p 59.94 Hz/60 Hz signals.
In [HDMI] mode, this is only enabled for the 640x480p 59.94Hz/60 Hz,
▶
1280x720p 59.94Hz/60 Hz signals from among the
1) Auto
2) RGB(PC)
3) RGB(AV)
4) YPbPr(AV)
When connecting the RGB output of a PC
RGB(PC)
to the D-Sub terminal
When connecting the RGB output of an
RGB(AV)
AV device (STB, DVD, etc...) to the D-
Sub terminal
When connecting the YPbPr output of an
YPbPr(AV)
AV device (STB, DVD, etc...) to the D-
Sub terminal
When connecting a PC to the HDMI
PC
terminal
AV
When connecting an AV device (STB,
H-Keystone'
Usage
Sharpness,Tint
AV Timing(D-
AV Timing(HDMI)
signals.
Color,
PC menu and
zoom
Disabled
Enabled
Enabled
Enable
Enabled
Disabled
Disabled
Enabled
Enabled
Disabled
Eco
Normal
Bright
Crosshatch
Screen
Size
Advertisement
