HP Jetdirect 640n Setup Manual page 33

Table A-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item
ENWW
Sub-menu item
Address
DHCPV6 Policy
Primary DNS
Secondary DNS
Proxy Server
Proxy Port
Sub-menu item Values and Description
Use this item to manually configure an IPv6 address.
Manual
enable and manually configure a TCP/ IPv6 address.
Enable: Select this item and choose
manual configuration, or
configuration.
Address: Use this item to type a 32 hexadecimal digit
IPv6 node address that uses the colon hexadecimal
syntax.
Router
method to be used by the print server is determined
by a router. The router specifies whether the print
server obtains its address, its configuration
information, or both from a DHCPv6 server.
Router
print server should attempt to obtain its stateful
configuration from a DHCPv6 server.
Always: Whether or not a router is available, the print
server always attempts to obtain its stateful
configuration from a DHCPv6 server.
Use this item to specify an IPv6 address for a primary
DNS server that the print server should use.
NOTE:
configuration is a higher priority than
Config Precedence table, configured through the
embedded Web server.
Use this item to specify an IPv6 address for a
secondary DNS server that the print server should
use.
NOTE:
configuration is a higher priority than
Config Precedence table, configured through the
embedded Web server.
Specifies the proxy server to be used by embedded
applications in the device. A proxy server is typically
used by network clients for Internet access. It caches
Web pages, and provides a degree of Internet
security, for those clients.
To specify a proxy server, enter its IPv4 address or
fully-qualified domain name. The name can be up to
255 octets.
For some networks, you may need to contact your
Independent Service Provider (ISP) for the proxy
server address.
Type the port number used by the proxy server for
client support. The port number identifies the port
reserved for proxy activity on your network, and can
be a value from 0 to 65535.
HP Jetdirect Menus for Graphical Control Panels
Settings: Use the Manual Settings
Off to disable manual
Specified: The stateful auto-configuration
Unavailable: If a router is not available, the
This item will appear only if
This item will appear only if
menu to
On to enable
Manual
DHCP in the
Manual
DHCP in the
25