HP Jetdirect 640n Setup Manual page 31

Table A-1 HP Jetdirect EIO Menu on Graphical Control Panel (continued)
Menu item
TCP/IP
ENWW
Sub-menu item
Configure Keys
Entry Method
Key (1 through 4)
Reset 802.11
Enable
Host Name
IPV4 Settings Config Method
DHCP Release
Sub-menu item Values and Description
Transmit Key Displays if
Format for WEP key entry.
Auto: Automatically generate a valid WEP key.
Alphanumeric: Alphanumeric ASCII characters (0–9,
a–z, A–Z). For 40/64-bit encryption, enter 5
characters. For 104/128-bit encryption, enter 13
characters. ASCII entries are case-sensitive.
HEX: Hexadecimal digits (0–9, a–f, A–F). For 40/64-
bit encryption, enter10 hexadecimal digits. For
104/128-bit encryption, enter 26 hexadecimal digits.
HEX entries are not case-sensitive.
The print server can store up to four WEP keys using
four key positions (Key 1, 2, 3, 4). To enter a WEP
key, specify the key position followed by the
encryption key value.
Reset the wireless 802.11 settings to their default
values
Off: Disable the TCP/IP protocol.
On
An alphanumeric string, up to 32 characters, used to
identify the device. This name is listed on the
HP Jetdirect configuration page. The default host
name is NPIxxxxxx, where xxxxxx is the last six digits
of the LAN hardware (MAC) address.
Specifies the method that TCP/IPv4 parameters will
be configured on the HP Jetdirect print server.
Bootp: Use BootP (Bootstrap Protocol) for automatic
configuration from a BootP server.
DHCP
Configuration Protocol) for automatic configuration
from a DHCPv4 server. If selected and a DHCP lease
exists,
available to set DHCP lease options.
Auto
address in the form 169.254.x.x is assigned
automatically.
Manual: Use the
TCP/IPv4 parameters.
This menu appears if
DHCP
No
Yes: The current DHCP lease and the leased IP
address are released.
HP Jetdirect Menus for Graphical Control Panels
WEP selected.
(Yes or No).
(default): Enable the TCP/IP protocol.
(default): Use DHCP (Dynamic Host
DHCP Release and DHCP Renew
IP: Use automatic link-local IPv4 addressing. An
Manual Settings
Config Method
and a DHCP lease for the print server exists.
(default): The current DHCP lease is saved.
menus are
menu to configure
was set to
23