Connecting The Brother Machine To The Wireless Network; Infrastructure Mode - Brother MFC 8890DW - B/W Laser - All-in-One Quick Setup Manual

For Wireless Network Users

Connecting the Brother machine to the wireless network

Configure the wireless
19
settings (Typical
Wireless Setup in

infrastructure mode)

a
On your machine, press Menu, 7 (Network), 2
(WLAN), 2 (Setup Wizard).
Press or
OK.
b
The machine will search for available SSIDs. If
a list of SSIDs is displayed, use
to choose the SSID you wrote down in step 18
on page 30, then press OK. Go to step f.
Note
It will take several seconds to display a list of
available SSIDs.
If your access point is set to not broadcast the
SSID you will have to manually add the SSID
name. Go to step c.
c
Press or
and press OK. Go to step d.
d
Enter the SSID you wrote down in step 18 on
page 30 using the dial pad to choose each
letter or number.
You can use
cursor left and right. For example, to enter the
letter a, press the 2 key on the dial pad once.
To enter the number 3, press the 3 key on the
dial pad seven times.
The letters appear in this order: lower case,
upper case and then numbers.
(For more information, see Entering Text for
Wireless Settings on page 44.)
Press OK when you have entered all the
characters.
e
Press or
Infrastructure, then press OK.
to choose On, then press
or
to choose <New SSID>
and to move the
to choose
f
Use the ,
one of the options below: If your network is
configured for Authentication and Encryption
you must match the settings used for your
network.
No Authentication or Encryption:
Choose Open System, press OK then use
or to choose None for
Encryption Type? and press OK. Then
press 1 for Yes to apply your settings. Go to
step k.
No Authentication with WEP Encryption:
Choose Open System, press OK then use
or to choose WEP for the
Encryption Type? and press OK.
Go to step g.
Authentication with WEP Encryption:
Choose Shared Key and press OK.
Go to step g.
Authentication with WPA/WPA2-PSK
(TKIP or AES) Encryption:
Choose WPA/WPA2-PSK and press OK.
Go to step h.
Authentication with LEAP:
Choose LEAP, press OK. Go to step i.
Authentication with EAP-FAST/NONE,
EAP-FAST/MS-CHAPv2, EAP-FAST/GTC
(TKIP or AES Encryption):
Choose EAP-FAST/NONE,
EAP-FAST/MSCHAP (EAP-FAST/MS-
CHAPv2) or EAP-FAST/GTC, press OK. Go
to step j.
g
Choose the appropriate key number and press
OK. Enter the WEP key you wrote down in
step 18 on page 30 using the dial pad to
choose each letter or number.
For example, to enter the letter a, press the 2
key on the dial pad once. To enter the number
3, press the 3 key on the dial pad seven times.
The letters appear in this order: lower case,
upper case and then numbers.
(For more information, see Entering Text for
Wireless Settings on page 44.)
Press OK when you have entered all the
characters, then press 1 for Yes to apply your
settings. Go to step k.
and OK keys to choose
31