Connecting The Brother Machine To The Wireless Network; For Windows Users; For Macintosh Users - Brother MFC-J615 Quick Start Manual

Table of Contents

Advertisement

For Wireless Network Users

Connecting the Brother machine to the wireless network

Configure the wireless
16
settings (typical Wireless
Setup in infrastructure
mode)
a
On your machine, press Menu.
Press a or b to choose Network and press
OK.
Press a or b to choose WLAN and press OK.
Press a or b to choose Setup Wizard and
press OK.
When Network I/F switched to
Wireless. is displayed, press OK to accept.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.
b
The machine will search for available SSIDs. If
a list of SSIDs is displayed, use the a or b keys
to choose the SSID you wrote down in
step 15-a on page 23, then press OK. If you
are using an authentication and encryption
method that requires a Password (Network
Key), go to c.
If your authentication method is Open System
and your encryption mode is None, go to d.
Note
It will take several seconds to display a list of
available SSIDs.
If a list of SSIDs is not displayed, make sure your
access point is on. Move your machine closer to
the access point and try starting from a again.
If your access point is set to not broadcast the
SSID, you will have to manually add the SSID
name. For details, see the Network User's
Guide on the documentation CD-ROM.
24
c
Enter the Password (Network Key) you wrote
down in step 15-a on page 23 using the dial
pad to choose each letter or number.
For example, to enter the letter a, press the 2
key on the dial pad once. To enter the number
3, press the 3 key on the dial pad seven times.
The letters appear in this order: lower case,
upper case and then numbers.
You can use the d and c keys to move the
cursor left and right.
(For more information, see Entering Text for
Wireless Settings on page 35.)
Press OK when you have entered all the
characters, then press 1 for Yes to apply your
settings.
d
Your machine will now try to connect to your
wireless network using the information you
have entered.
It may take a few minutes to connect to your
wireless network.
e
A connection result message appears for
60 seconds on the LCD and a wireless LAN
report will automatically be printed. If the
connection failed, check the error code on the
printed report and refer to Troubleshooting
on page 26.
Wireless setup is now complete. A four
level indicator on the bottom of your
machine's LCD will show the wireless
signal strength of your access
point/router.
To install MFL-Pro Suite, continue to
step 17.
®
For Windows
Users:
Now go to
Page 28

For Macintosh Users:

Now go to
Page 32

Advertisement

Table of Contents
loading

Subscribe to Our Youtube Channel

Table of Contents