Fiery KM-C2230 Color Manual page 69

2
2-31 Using AutoCal and ColorCal
8. For Measurement Method, choose AutoCal or ColorCal.
9. Choose Calibrate.
10. Select the Calibration Set.
11. When prompted, choose Yes to print the measurement page.
12. Choose Yes in the Measure Page screen.
13. When prompted on the Control Panel, place the Kodak Gray Scale strip face-down on
Place grayscale strip face down
14. Place the color measurement page face-down over the grayscale strip.
Choose from the list of all calibration sets on the Fiery X3e. This prompt appears only
if more than one calibration set is available.
This page is comprised of swatches of color that will be measured by the
copier/printer's scanner and then compared to the target color values. After the page is
printed, the Measure Page screen appears.
the copier/printer glass.
Place the strip along the top edge of the copier/printer so that it is centered between
the paper width marks on the copier/printer.
Place the page at the upper-left corner of the copier/printer glass. Slide the grayscale
strip to the top center of the color measurement page. Make sure the patches on the
grayscale strip do not overlap the color patches.
Close the platen glass cover, being careful not to move the grayscale strip and color
measurement page.
Place color measurement page face
down over grayscale strip