Table of Contents
Advertisement
6.
Serial port connector (10-1 pin COM2)
This connector is for a serial (COM) port. Connect the serial port module
cable to this connector, then install the module to a slot opening at the back
of the system chassis. The serial port module is purchased separately.
P5M2 Series COM Port Connector
7.
SAS LSI1068 ports LED connector (18-1 pin SASLED1)
( For P5M2/SAS model only )
This connector is for SAS link state's LED. The active LOW Fault LED signals
are nominally configured to indicate a SAS link fault for each respective phy.
The active LOW Activity LED signals are nominally configured to indicate
SAS link activity.
P5M2/SAS SAS LED Connector
2-2
COM 2
PIN 1
SASL ED1
Chapter 2: Hardware information
Hide quick links:
Advertisement
Table of Contents
