Preparation For Use; Unpacking And Setup - Emerson RS1008 Owner's Manual

UNPACKING AND SET-UP
• Carefully remove all of the components and confirm that you have the following:
1.) Center Stand with Subwoofer x 1.
2.) Tower Speakers x 2.
3.) Receiver/CD Player Unit x 1 (with FM Antenna Wire attached).
4.) Remote Control x 1.
5.) Speaker Cables x 2.
6.) Subwoofer Connection Cable x 1.
• Position the Center Stand with Subwoofer unit in the desired location. Note that this system requires two
AC outlets. If you do not have two outlets available in the desired location you may have to use a UL
Listed multi-outlet surge protector, or power-strip, not included.
• Note that there are two exposed screws on the front side of the Center Stand. These screws are aligned
with two matching "keyholes" on the back of the Receiver/CD Player unit. Hold the Receiver/CD player
unit facing you with two hands. Position the Receiver/CD Player against the stand so that the two mounting
screws on the stand fit into the two "keyholes" on the back of the Receiver/CD Player.
KEY HOLES
BACK VIEW
Hint: It' s easier to do this if you are looking down from the top as you position the Receiver/CD
Player against the center stand. When the two mounting screws are inside the two keyholes, slide
the Receiver/CD Player unit slightly downward to lock the unit in place. If it should become necessary
to remove the Receiver/CD Player unit from the center stand, slide the unit upward slightly to
' unlock' it, and then pull the unit gently toward you.
• After you have mounted the Receiver/CD Player unit on the Center Stand unwind the FM Antenna Wire
that is attached to the back panel of the Receiver/CD Player unit and let the wire hang freely against the
back of the Center Stand.
IMPORTANT: Save the carton and all packing materials until the system has been completely
set up and is operating properly. The retail store cannot accept the return of this system without
the original carton and all packing materials.
RS1008_ib042303.p65

PREPARATION FOR USE

FRONT VIEW
4
4
23/4/2003, 14:51
HANGING SCREWS