Preparation For Use; Speaker Connection; Connecting The Ac Power Cord; Stereo Headphone Jack - Emerson MS9923TT Owner's Manual

PREPARATION FOR USE

SPEAKER CONNECTION

Connect each speaker to the corresponding speaker terminals on the back panel
of the main unit. Make sure that the left speaker is connected to the left pair of
speaker terminals and the right speaker to the right pair of speaker terminals. Also
make sure that the speaker wires are correctly connected: that the red wires are
connected to the red terminals and the black wires to the black terminals.
Depress the plastic lever to open the terminal, insert the bare end of the speaker
wire into the opening and release.
BLACK
RED
R L
SPEAKERS : 4

CONNECTING THE AC POWER CORD

After connecting the speakers unwind the AC power cord fully and connect it to any
convenient household AC outlet. This system is designed to operate on 120V,
60Hz AC power only. Connecting this system to any other power supply may
cause damage to the unit which is not covered by your warranty.

STEREO HEADPHONE JACK

A stereo headphone jack is provided for private listening. To listen to the unit with
headphones (not included) insert the 3.5mm mini-stereo plug from the headphones
into the PHONES jack on the front panel. The external speakers are automatically
disconnected when headphones are in use.
NOTE:
We recommend that you reduce the volume control to a lower level before putting
on the headphones. After putting on the headphones, gradually increase the volume
to a comfortable listening level.
7
MS9923TT_ib_0416.p65 7 16/4/2002, 14:17