Table of Contents
Advertisement
• Avoid installing this unit in places exposed to
direct sunlight or close to heat radiating
appliances such as electric heaters, on top of
other stereo equipment that radiates too much
heat, places lacking ventilation or dusty areas,
places subject to constant vibration and/ or
humid or moist areas.
• Do not attempt to clean this unit with chemical
solvents as this might damage the finish. Use
a clean dry cloth.
CLASS 1 LASER PRODUCT
APPAREIL Á LASER DE CLASSE 1
This product contains a low power Laser Device.
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
RS1008_ib042303.p65
IMPORTANT NOTES
CLASS 1 LASER PRODUCT
PRODUCTO LASER DE CLASE 1
3
• Operate controls and switches as described
in the manual.
• Before turning ' On' the power, make certain
that power cord is properly installed.
• Store your CDs, in a cool area to avoid
damage from heat.
• W hen moving the set, be sure to first
disconnect the power cord.
CAUTION
INVISIBLE LASER RADIATION
WHEN OPEN AND INTERLOCKS
DEFEATED.
AVOID EXPOSURE TO BEAM
3
23/4/2003, 14:51
Advertisement
Table of Contents
