T2000Wd/1 - EarthQuake T1000W/2 Owner's Manual

T2000WD/1

HIGH LEVEL LOW LEVEL INPUTS:
INPUT: Low level inputs with a
Speaker level range of 0.2V to 7V RMS.
inputs with a This is where the front and
range of 0.5V rear RCA outputs from your
to 17V RMS. head unit or other devices
are inserted.
AUTO ON
R C A l i n e PHASE SHIFT: AUTO SIGNAL
t h r o u g h t o This 0 - 180° phase SENSING:
c a s c a d e shift adjustment is Please refer to
a n o t h e r for reversing the p a g e 3
amplifier. phase output with explanation of this
N o X o v e r respect to its input. feature.
point.
The gain knob is not a volume
control. It is designed to match
POWER LED:
the input level of the amp to the
When LED is on, it output level of the source unit.
indicates that the Over driving "clipping" the input
amplifier is ON and stage of the amp will cause
f u n c t i o n i n g damage to the amplifier (please
properly. refer to table for setting).
PROTECTION (PROT) LED:
If LED comes on then you have an
issue that requires service. Turn
off the amplifier and call
Earthquake for further assistance.
See warranty for details.
12
Specifications Are Subject To Change Without Notice
SUBSONIC FILTER: LEVEL ADJUST:
For the vast majority of Allows the amplifier to deliver a
vehicles, peaks or dips controlled maximum sound level into
occur at about 40Hz – selected channel(s) when the volume
around the frequency of is turned to max. This acts as a
a low bass guitar note. volume limiter for the system,
Use this control to preventing you from over driving the
correct that peak or dip. speakers or subwoofers.
RESET REMOTE ON
LOW PASS FILTER (LPF): 0 - 10dB REMOTE SUB LEVEL:
Allows you to limit the
This 50Hz - 300Hz low- BASS
pass filter blocks unwanted BOOST amplifier's
from a location of your
f o r h i g h f r e q u e n c i e s f o r CONTROL
cleaner low-frequencies. choice. Using a
mounted remote control.
SUB
XOVER
SETTING
50Hz 70Hz 150Hz 210Hz
MAX INPUT
VOLTAGE
BEFORE
CLIPPING
7.0V 4.0V 2.5V
RCA LEVEL
SPEAKER
17.0V 10.0V 5.0V
LEVEL
To battery positive (+) Two
30A
fuses
To remote turn on / trigger
To car chassis / ground
8-gauge
speaker
outputs
bass output
screw
240Hz 300Hz
1V
1V
AUTO ON RESET REMOTE ON
AUTO ON RESET REMOTE ON
www.earthquakesound.com
13