T2000W/4 - EarthQuake T1000W/2 Owner's Manual

T2000W/4

HIGH LEVEL LEVEL ADJUST:
INPUT: Allows the amplifier to deliver a controlled
Speaker level maximum sound level into selected
inputs with a channel(s) when the volume is turned to
range of 0.5V max. This acts as a volume limiter for the
to 17V RMS. system, preventing you from over driving
the speakers or subwoofers.
AUTO ON RESET REMOTE ON
LOW LEVEL INPUTS: AUTO SIGNAL
Low level inputs with a SENSING:
range of 0.2V to 7V RMS. Please refer to page 3 for
This is where the front and e x p l a n a t i o n o f t h i s
rear RCA outputs from your feature.
head unit or other devices
are inserted.
The gain knob is not a volume
control. It is designed to match
the input level of the amp to the
output level of the source unit.
Over driving "clipping" the input
stage of the amp will cause
damage to the amplifier (please
refer to table for setting).
Bridgeable Speaker
outputs, minimum
4-Ohms mono.
10
Specifications Are Subject To Change Without Notice
This information applies to
both channels 1/2 and 3/4
MODE SELECTOR: 2-WAY 12dB/Oct
This feature tells the VARIABLE XOVER:
amplifier to run in C o n t r o l t h e
either HIGH PASS, corresponding channels
FULL RANGE or cutoff frequencies. This
LOW PASS MODE feature is disabled when
in FULL RANGE
BASS BOOST: PROTECTION (PROT) LED:
0 - 18dB Bass If LED comes on then you have an
Boost for use issue that requires service. Turn
w i t h off the amplifier and call
subwoofers. Earthquake for further assistance.
See warranty for details.
XOVER
KNOB
SETTING
50Hz 90Hz 125Hz 170Hz
T2000W/4
MAX INPUT
VOLTAGE
BEFORE
CLIPPING
7.0V 4.0V 2.5V
RCA LEVEL
SPEAKER
17.0V 10.0V 5.0V
LEVEL
To car chassis / ground
Two
20A
To remote turn on / trigger fuses
To battery positive (+)
R C A l i n e
t h r o u g h t o
c a s c a d e
a n o t h e r
amplifier.
N o X o v e r
point.
Set Xover switch
to FULL
POWER LED:
When LED is on, it
indicates that the
amplifier is ON and
f u n c t i o n i n g
properly.
210Hz 250Hz
1V
1V
FC6.2 Midrange FC6.2 Midrange
FC6.2 Xover FC6.2 Xover
CH1 CH2
FC6.2 FC6.2
Tweeter Tweeter
CH3 CH4
FC6.2 Midrange FC6.2 Midrange
FC6.2 Xover FC6.2 Xover
FC6.2 FC6.2
CH1 CH2
Tweeter Tweeter
CH3 CH4
K-10, ten-inch bass tube, in mono
application (4 Ohms minimum)
www.earthquakesound.com
11