Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for EarthQuake Cinenova 7300
Summary of Contents for EarthQuake Cinenova 7300
- Page 1 Cinénova 7 7 CHANNEL, CLASS AB AMPLIFIER User Manual...
-
Page 2: Table Of Contents
©2021 Earthquake Sound Corporation. All rights reserved. sume liability for damages resulting from the direct use This document should not be construed as a commitment on the part of Earthquake Sound Corporation. of Earthquake Sound audio product(s) and urges users The information is subject to change without notice. -
Page 3: Warranty Information
Product(s) must be packaged in its original protective box(es) to minimize transport (C) Earthquake will repair or replace - at our option - all defective products/parts damage. Shipper claims regarding items damaged in transit must be presented to subject to the following provisions: carrier. -
Page 4: About Cinénova 7300 Amplifier
Completely separate output blocks are largely unheard of in this class of amplifier, of time. but with Earthquake’s enduring strive for quality and excellence there simply was � Refer all servicing to qualified service personal. Servicing is required when the no other way. -
Page 5: Front Panel Overview
Cinénova 7300 Front Panel Overview 1. Master Power Switch: Peak LED Indicators: Turns the current to the amplifier ON or OFF manually. When turning The Cinénova 7300 is equipped with seven LED indicators on the on the amplifier via a 12VDC source the switch must be in the OFF front panel that should remain unlit. -
Page 6: Rear Panel Overview
Cinénova 7300 Rear Panel Overview 1. RCA Input: Accepts low-level signal from any source, such as a processor or receiver. From 0.4 Vac up to 6 Volt AC. 2. Input Selector: To maintain signal integrity Cinénova 7300 provides you with an “Input Selector Switch”. -
Page 7: Pre-Setup
Getting Started With The Cinénova 7300 Confirm the voltage setting of the amplifier. It must match the voltage in your home. The amp is set by factory to either 120V or 240V. Check above the circuit breaker for this information. 1) INPUT SELECTION 2) SPEAKER CONNECTIONS Amplification Block Plate... -
Page 8: Specifications & Dimensions
Cinénova 7300 Specifications & Dimensions MODEL Cinénova 7300 Chassis Dimensions (H x W x D) 7ʺ x 17ʺ x 17.12ʺ (178mm x 432mm x 435mm) Number of Channels 7-channels Front Plate Dimensions (H x W) (8-ohm load) Rated: 180 WRMS Power Rating Per Channel (4-ohm load) Rated: 300 WRMS 7ʺ... -
Page 9: Troubleshooting
If Problems Persist It is normal when running the amplifier to full power that the LED's flicker. If the LED's Contact Earthquake Sound Technical Service are on constantly without flickering (solid orange) it means that the amplifier output is Phone: 1-800-576-7944 or 510-732-1000 clipping. -
Page 10: For Your Records
For Your Records Date of Purchase: ________________________ Authorized Dealer/Installer Info: Name: _____________________________________ Address: _____________________________________ _____________________________________ Phone: _____________________________________ Serial Number: specifications are subject to change without notice... -
Page 11: Notes
Notes www.earthquakesound.com... - Page 12 Earthquake Sound reserves the right to amend details of the specifications without notice. © Copyright Earthquake Sound Corporation Earthquake Sound Corporation 2727 McCone Avenue, Hayward CA, 94545 Phone: (510) 732-1000 U.S. Toll Free: (800) 579-7944 Fax: (510) 732-1095...