T1000W/2 - EarthQuake T1000W/2 Owner's Manual

T1000W/2

HIGH LEVEL LEVEL ADJUST:
INPUT: Allows the amplifier to deliver a controlled
Speaker level maximum sound level into selected
inputs with a channel(s) when the volume is turned to
range of 0.5V max. This acts as a volume limiter for the
to 17V RMS. system, preventing you from over driving
the speakers or subwoofers.
LOW LEVEL INPUTS: BASS BOOST: AUTO SIGNAL
Low level inputs with a 0 - 18dB Bass SENSING:
range of 0.2V to 5V RMS. Boost for use Please refer to page 3 for
This is where the front and w i t h e x p l a n a t i o n o f t h i s
rear RCA outputs from your subwoofers. feature.
head unit or other devices
are inserted.
The gain knob is not a volume
control. It is designed to match
the input level of the amp to the
output level of the source unit.
Over driving "clipping" the input
stage of the amp will cause
damage to the amplifier (please
refer to table for setting).
To car chassis / ground
Bridgeable Speaker
outputs, minimum
To remote turn on / trigger
4-Ohms mono.
To battery positive (+)
8
Specifications Are Subject To Change Without Notice
This information applies to
both HPF and LPF
MODE SELECTOR: 2-WAY 12dB/Oct R C A
This feature tells the VARIABLE XOVER: t h r o u g h t o
amplifier to run in C o n t r o l t h e c a s c a d e
either HIGH PASS, corresponding channels a n o t h e r
FULL RANGE or cutoff frequencies. This amplifier.
LOW PASS MODE feature is disabled when N o
in FULL RANGE point.
AUTO ON RESET REMOTE ON
PROTECTION (PROT) LED: POWER LED:
If LED comes on then you have an When LED is on, it
issue that requires service. Turn indicates that the
off the amplifier and call amplifier is ON and
Earthquake for further assistance. f u n c t i o n i n g
See warranty for details. properly.
XOVER
KNOB
SETTING
T1000W/2 50Hz 90Hz 125Hz 170Hz 210Hz
MAX INPUT
VOLTAGE
BEFORE
CLIPPING
7.0V 4.0V 2.5V 1V
RCA LEVEL
SPEAKER
17.0V 10.0V 5.0V 1V
LEVEL
Two
25A
fuses
l i n e
X o v e r
Set Xover switch
to FULL
250Hz
FC6.2 FC6.2
Tweeter Tweeter
FC6.2 Xover FC6.2 Xover
FC6.2 Midrange FC6.2 Midrange
K-10, ten-inch bass tube, in mono
application (4 Ohms minimum)
www.earthquakesound.com
9