Changing The Fuse - Dynaudio SUB 600 Owner's Manual

Care and Maintenance

Changing the fuse

Risk of Fire
WARNING
 For continued protection against risk of fire, replace only with same type fuse and
rating.
The fuse is placed on the rear of the subwoofer below the mains power input. It can be
100-120V/220-240V
changed without removing the amplifier module.
~ 50/60Hz 3.15A
ON
To change the fuse:
1. Switch off the mains power switch and unplug the power cable.
2. Pull out the fuse holder
OFF
3. Replace fuse with same type and rating
FUSE T3.15A L 250V
4. Push fuse holder back firmly until it is locked in its position.
Recycling used products
This product is subjected to the European Union Waste Electrical and Electronic
Equipment directive (WEEE), 2002/96/EC.
This product must not be disposed of as unsorted municipal waste but must be collected
separately and disposed according to your national regulations.
Owners Manual 33