Connecting A Single Subwoofer - Dynaudio SUB 600 Owner's Manual

OPERATION
SAT Highpass
Flat 60 Hz
➊ ➋
Front Out/ LFE/SUB Out
Pre Out
LEFT
RIGHT
SUB I/O
LFE
12

Connecting a single subwoofer

➊
POWER GAIN PHASE
ON AUTO 0° 180°
 From the preamplifier output of your processor/receiver, PC or mediaplayer (often
Min Max
SUB Lowpass
80 Hz
50 Hz 150 Hz
This signal should not be already processed by the processor/receiver. Please pay
attention to the settings of your processor/receiver.
SAT/SUB Input SAT Output
➋
 From the processor or receiver's low-level (not a speaker output) subwoofer output
LFE / Slave IN OUT
This signal should not be already processed by the processor/receiver. Please pay
To Slave
attention to the settings of your processor/receiver.
Slave
 Set the MODE switch to LFE.
Note:
To connect the SAT/SUB input:
marked as Pre Out or Front Out) connect a stereo RCA cable to the subwoofer SAT/
SUB Input.
To connect the LFE channel:
(often marked as "subwoofer out", "Sub out" or "LFE"), connect a mono RCA-to-RCA
cable to the subwoofer input SUB I/O - LFE/Slave IN.
You also can use both connection types. Both signals will be combined in the
Sub 600 and routed accordingly. This allows the Sub 600 to reproduce both the
LFE channel information as well as the bass range of the connected satellite
speakers
Dynaudio Sub 600