Related Manuals for Dynaudio SUB 300
Summary of Contents for Dynaudio SUB 300
- Page 1 Dynaudio Sub Owners Manual/Bedienungsanleitung Home Systems I Professional I Automotive I Multimedia...
-
Page 2: Table Of Contents
Connecting a single subwoofer ................7 Connecting multiple subwoofers ................. 8 Connecting using the XLR sockets ..............8 Operating the subwoofer ..................9 Dynaudio Sub 300 Fitting the remote control battery................. 9 Switching on/off ....................10 Changing the volume level (LEVEL) ..............12 Setting the cross-over frequency (CROSSOVER FREQUENCY)..... -
Page 3: Dear Music Lover
These facilities are so advanced and the quality control is so strict that Dynaudio is likely the only specialty audio company to have exceeded ISO 9000 and earned QS 9000 certification. Each Subwoofer model is constructed by Dynaudio's master craftsmen in Denmark to these high standards of quality. -
Page 4: Important Safety Instructions
16.To completely disconnect this equipment from the mains, disconnect the power supply cord plug from the receptacle. 17.The mains plug of the power supply cord shall remain readily operable. Dynaudio Sub 300/500... -
Page 5: Safety Signs
CAUTION not avoided, could result in minor or moderate injury or damage to equipment. Indicates in combination with a safety sign a potentially hazardous situation which, if WARNING not avoided, could result in death or serious injury. Dynaudio Sub 300/500... -
Page 6: About This Operating Manual
Multiple steps that should be performed consecutively are numbered. Please follow these instructions carefully. italics The result of a step is printed in italics. This may help you verify the success of a step. bold-grey Controls are printed in bold-grey type face. Dynaudio Sub 300/500... -
Page 7: Unpacking
Gently straighten up the grille until the top magnets of the grille meet the top bolts of the baffle. The magnets will click into place. The grille is now attached to the baffle. To remove the grille: Removing the grille is the same procedure in reverse. Dynaudio Sub 300/500... -
Page 8: Controls And Connections
Before Operation Controls and connections Remote Eye Subwoofer back panel D NAUDIO Remote Eye Dynaudio A/S - Skanderborg - Denmark Master Store Infrared receiver. Preset Input Settings Function Slave Protect Input Function Subwoofer operation mode: Master or Slave • Master: setting if just one subwoofer is used or for first subwoofer if system... -
Page 9: Connecting The Subwoofer
NOTICE • The Dynaudio Sub 300/500 can be controlled by any source provided with a LFE or preamplifier output. In the operating manual the expression “processor/receiver” will be used for all these sources. -
Page 10: Connecting Multiple Subwoofers
Provided your processor or receiver has a XLR symmetric or balanced output for subwoofer you should consider using the XLR input on the Dynaudio subwoofer. In a setup with multiple subwoofers you can use the XLR connections between the Master and Slave subwoofers, even if the connection between the processor or receiver has been made using the RCA connectors. -
Page 11: Operating The Subwoofer
• Use only CR2025 button cell batteries to replace the original battery with. These are readily available from most electrical stores. • Do not leave the remote control in high temperature environments (such as in direct sunlight) as it can possibly result in deformation of the remote's case. Dynaudio Sub 300/500... -
Page 12: Switching On/Off
Note that if no music signal presents itself within 20 minutes, the subwoofer will switch back to Standby again. Briefly pressing the red button will switch it to Standby. If the music signal is still present, it will switch to On again immediately. Dynaudio Sub 300/500... - Page 13 • When powering up, the subwoofer always reverts to the same settings as when it was switched off. Even if mains power is removed completely for a prolonged period of time, the last settings will be retained. Dynaudio Sub 300/500...
-
Page 14: Changing The Volume Level (Level)
PRESET Slave mode (refer also to “Master and Slave mode” on page 7). D NAUDIO A U T H E N T I C F I D E L I T Y Dynaudio Sub 300/500... -
Page 15: Activating The Bass Extension (Ext)
Activating the bass extension (EXT) LEVEL POWER stands for Extension, in this case “Low Frequency Extension”. Dynaudio subwoofers allow for deep and accurate bass response even at high levels. In the EXT OFF mode, the very deepest bass will be mildly filtered; this will allow the subwoofer to achieve even higher sound pressure levels. -
Page 16: Storing And Recalling Presets (Preset)
This way you always have a starting PRESET and reference point. D NAUDIO A U T H E N T I C F I D E L I T Y Master Store Input Preset Function Settings Protect Slave Dynaudio Sub 300/500... -
Page 17: Positioning The Subwoofer
Remember that the Dynaudio subwoofers allow for 4 different preset settings, so you can store a preset with the setting that matches the occasion (be it for action movie or music listening) best. -
Page 18: Corner Placement
Always position subwoofers at least 1 mtr/3 ft away from a television as the magnetic field emanating from the subwoofer may otherwise distort the picture. If you see discolorations on the television screen, try moving the subwoofer and other speakers close by away from the television. Dynaudio Sub 300/500... -
Page 19: Finding The Correct Settings
When using multiple subwoofers, ensure that all settings such as level, cross-over frequency, phase and LF extension are identical. Use the Master and Slave mode options to ensure that all subwoofers operate on the same settings (refer to “Master and Slave mode” on page 7). Dynaudio Sub 300/500... -
Page 20: Cross-Over Frequencies
In the other case you will experience unnatural and bloated bass sound, if the Main speakers overlapping area is too large. The combined frequency response shows a bump, as the sound pressure levels in this area are increased. Frequency Dynaudio Sub 300/500... - Page 21 Again play the track to listen to the overall bass volume level. Should the bass volume suddenly become louder or bloated at certain tones compared to the 80 Hz setting earlier, revert to this setting. If the bass sounds correct now, leave the setting at 100 Hz. Dynaudio Sub 300/500...
-
Page 22: Phase
4. If it appears that the bass is too much reduce the volume level until it sounds homogeneous. FLAT PHASE PRESET D NAUDIO A U T H E N T I C F I D E L I T Y Dynaudio Sub 300/500... -
Page 23: Troubleshooting
There may be various reasons why the subwoofer doesn’t function properly in a system without it being faulty. The checklist below will help solve problems you may encounter. Before consulting your Dynaudio dealer, check this list first. Check this first: Check if all signal cables are connected properly. - Page 24 • Subwoofer volume level has been turned down all the connected amplifier or receiver. way with the subwoofer’s remote control. Carefully and gradually increase the subwoofer volume level on the amplifier or receiver. Carefully and gradually increase the subwoofer volume level with its remote control. Dynaudio Sub 300/500...
-
Page 25: Changing The Fuse
The power Status LED will start to flash green. 5. Release the PRESET A button. The subwoofer is now reset to the factory default settings. Note • All previously stored presets will be deleted also when resetting to factory defaults. Dynaudio Sub 300/500... -
Page 26: Technical Specifications
All aspects relating to the performance criteria are strictly controlled. Along all stages of the entire production progress – from raw material selection to the final assembly and quality control – Dynaudio thoroughly inspects each parameter along every step of way. -
Page 27: Warranty
Troubleshooting and Technical Information Warranty Dynaudio provides a transferable five-year limited manufacturer’s warranty on speaker parts. (Integrated electronics feature a two year warranty!) This warranty only covers faults or defects in material and production. Damage caused as a result of abuse, misuse or defective associated electronics is not covered by the warranty. - Page 28 Sales & Marketing: Dynaudio International GmbH, Ohepark 2, 21224 Rosengarten, Germany, Phone: +49 4108 - 41 80 - 0 www.dynaudio.com © Dynaudio International GmbH, Sub Manual 0510, Item-No. 455295C. All text and image copyrights reserved. Subject to change without notice.
Need help?
Do you have a question about the SUB 300 and is the answer not in the manual?
Questions and answers