Technical Information/Warranty; Changing The Fuse; Technical Specifications - Dynaudio SUB 250 Operating Manual

Technical Information/Warranty

Dynaudio SUB 250

Changing the fuse

For continued protection against risk of fire, replace only with same type fuse and
rating.
The fuse is placed on the rear of the subwoofer below the mains power input. It can
be changed without removing the amplifier module.
Changing the fuse
1. Switch off the mains power switch and unplug the power cable.
2. Pull out the fuse holder
3. Replace fuse with same type and rating
4. Push fuse holder back firmly until it is locked in its position.

Technical Specifications

Parameter
System
Bass principle
Frequency response
Inputs
SUB I/O: LFE/Slave In
SAT/SUB Input
Input impedance
LFE/Slave In
SAT/SUB Input
Outputs
SUB I/O: LFE/To Slave
SAT Output
Output impedance
LFE/To Slave
SAT Output
Mode selector
Phase adjustment
SAT Highpass
Technical Information/Warranty
WARNING
RISK OF FIRE!
Data
Active subwoofer
Closed
29 Hz to 250 Hz (+/-3 dB)
RCA
right/left full bandwidth, RCA
10 kOhm at 1 kHz
>8 kOhm at 1 kHz
RCA
right/left, Highpass filtered, RCA
100 Ohm
100 Ohm
LFE, Slave (Phase and volume controls are bypassed
in slave mode).
0°, 180°
Flat, 60 Hz, 80 Hz,
19