Controls And Connections - Dynaudio SUB 600 Owner's Manual

BEFORE OPERATION
➋
POWER GAIN PHASE
➊ ON AUTO 0° 180°
Min Max
SAT Highpass SUB Lowpass
➍
Flat 60 Hz 80 Hz
50 Hz 150 Hz
SAT/SUB Input SAT Output
LEFT
➏
RIGHT
LFE / Slave IN OUT
➐
SUB I/O
➑
LFE Slave
100-120V/220-240V
~ 50/60Hz 3.15A
ON
➒
OFF
FUSE T3.15A L 250V
8

Controls and connections

➊
POWER
Subwoofer auto power mode:
➌
➎
➋
GAIN
Subwoofer volume level.
➌
PHASE
Phase setting: phase can be set to 0° or 180°.
➍
SAT Highpass
Allows cutting off low frequencies of the signal provided at the SAT Output:
To Slave
➎
SUB Lowpass
Subwoofer lowpass frequency: continuously variable from 50 to 150 Hz.
➏
SAT/SUB Input, SAT Output
➓
• ON = Auto mode disabled (subwoofer is switched on permanently, when main
power switch is set to ON).
• AUTO = Auto mode enabeld (when main power switch is set to ON and a music
signal is detected, the internal amplifier is activated automatically).
• Flat = signal is not processed
• 60 = cut-off frequency at 60 Hz
• 80 = cut-off frequency at 80 Hz
• SAT/SUB Input: Input for full bandwidth signal from processor/receiver. This
signal will be processed according to the SAT Highpass setting and provided at
the SAT Output connection for satellite speakers to be connected.
• SAT Output: Output for satellite speakers to be connected. This signal is
processed according to the SAT Highpass setting.
Dynaudio Sub 600