Honeywell Dolphin Power Tools User Manual page 56

Profile Subsections–Dolphin 7850
Each Profile subsection contains the keys that configure the radio connection from the terminal to the
network.
Key Description
• CA certificates are any certificates
CA and/or
created by a certified authority (CA).
Client
• Client certificates contain information
Certificate
that identifies the user, as well as
information about the organization that
issued the certificate. This ensures
that you can encrypt data end-to-end.
Private Key Private keys are used with certain types
of EAP authentication.
Priv Key Private keys can be locked by
passwords.
Password
WEP Key Mode being used by the WEP keys (in
Key1–Key4 keys).
Mode
Note: Key validation occurs when
WEP Key1– In fields Key 1—Key 4, enter the specific
key. The format of each key must match
Key4
the key length type selected in the WEP
Key Mode key.
To use dynamic keys in your
configuration, leave all the key fields
blank.
Active Key Enter the number of the key that you
want to be active in this configuration.
NonSupplicant Section–Dolphins 7900 and 9500
Key Description
SSID The service set identifier used to
connect to network; usually the network
name of the access point or peer station.
3 - 6
DeviceConfig is loaded on the
terminal (often during Autoinstall),
not when you save the
DeviceConfig.exm file.
Default Available Values
Value
N/A Enter the address on the Dolphin
terminal of either certificate (CA or
Client).
The certificates must be located on
the Dolphin terminal!
N/A Enter the address on the Dolphin
terminal of the private key.
The private key must be located on
the Dolphin terminal!
N/A Enter the password that unlocks the
private key.
N/A ASCII uses all alpha numeric
characters. HEX uses only numerics
and A-F.
Valid lengths are as follows:
• 64-bit ASCII=5
• 128-bit ASCII=13
• 64-bit HEX=10
• 128-bit HEX=26
N/A User-defined
N/A 1, 2, 3, or 4
Defaul Available Values
t Value
N/A X=Your network's SSID
Any=Connect to any network