Honeywell Dolphin Power Tools User Manual page 38

Field Description
Max Barcode Set the maximum amount of data (in bytes) one bar code can contain. The lower the
number of bytes, the smaller the bar code. Bar code size is displayed to the right of the
Size
Display
of the window; see
Always use This option is selected by default. It calibrates the data so that the minimum number of bar
codes are used. When this option is selected, the number of bar codes slider on the Bar
minimum # bar
Codes tab is disabled.
codes
Full screen This option runs the deployment progress dialog box on the terminal in full screen mode
so that the user cannot open another application while the bar codes are being deployed
progress dialog
on the terminal.
Warm boot after This option automatically launches a warm boot on the terminal after the bar code is
deployed. Use this options with EXM files that contain application information requiring a
finished
warm boot to take effect, such as registry settings.
Deployment Options–These options determine how to deploy the EXM file embedded in the bar
code. For each deployment option selected, there are corresponding overwrite options under If
already exists, deploy:.
Replace remote Replaces the existing file; no section-level merge modes are applied.
If already exists, deploy:
file
•
•
•
•
Merge each Deploys information according to the section-level merge mode settings; see
Level Merge Modes
section...
If already exists, deploy:
(Default
• Always—Select to always use the section-level merge mode settings.
selection)
• Only if newer—Select to use the section-level merge mode settings only if the sections
Temporary Deploys the EXM file temporarily. The settings in the EXM file are applied, but the file does
not remain in the system after EZConfig Client is done.
If the terminal contains a previous EXM file with the same name, the previous EXM file is
preserved.
Persist Bar Code Stores the settings from the Options, Bar Codes, and Web Page tabs within the EXM file
so that the same bar code settings are applied the next time a bar code is created. This
Settings
increases the size of both the EXM file and the bar code(s).
If the Simplify option is selected, bar code setting information is not included in the bar
code but remains in the open EXM file.
2 - 22
(page 2-20) field. The total number of bar codes created is displayed at the bottom
Bar Codes
Always
—Select to always replace the existing file.
Only if newer
—Select to replace the existing file only if the file in the bar code is newer
than the existing.
Never
—Do not deploy the new file; this preserves the existing file.
Prompt
—EZConfig Client asks the user if they want to overwrite the existing file during
deployment.
on page
are newer than the existing file.
(page 2-23).
2-10.
Section-