Directed Electronics MERLIN 2000 Installation Manual page 22

Hide thumbs Also See for MERLIN 2000:

Table of Contents

The siren sounds weak or garbled:

I Check all the grounding points, including the siren ground and alarm ground.

I Check the alarm for 12V output on the H1/9 BROWN wire.

I For all motorcycle and recreational vehicle installations, a direct battery ground is recommended.

The starter kill does not work:

I Does the H1/8 YELLOW wire test 12 volts during the crank or start cycle? If not, you may not have the true

ignition wire.

I Is the correct starter wire being interrupted?

A sensor is not working:

I NPC

may have been activated and the sensor may be bypassed. Insert the key and turn on the ignition to

reset the alarm.

I Is the sensor initiating a trigger? Use a digital multimeter to determine whether or not the sensor is working.

I Is the LED lit solid? The system may be in Valet Mode. (Refer to the Valet Mode section of the owner's guide.)

You cannot enter the programming mode with the Valet switch:

I Is the Valet switch in the correct port? (Refer to the Plug-In LED and Valet/Program Switch section of this guide.)

I Does the Valet switch have continuity when pressed?

I Does the alarm test 12 volts upon ignition?

The lights do not flash:

I Check the fuses on the H1/6 and H1/14 WHITE wires. Also check for 12-volt output on the H1/6 and H1/14

WHITE wires.

I Make sure that the system is connected to a parking light lead, rather than an illumination lead.

Table of Contents

Show Quick Links

Chapters

Table of Contents